开云体育

I have a question about IR detectors. My IR detectors are directly connected to a dr4088ln-opto (see attachment). This works. My question is, can they be directly attached to a dr4088LN-cs or do I

@James Hudson ??

Hello everyone. I've purchased 3 YD6016RB sensor boxes. The first box has 12 outputs and is connected via the R BUS which all work perfectly but when I connect a second box, I get flashing occupied

Hi Gordon, This is kind-a dead group, Better aske here: /g/Digikeijs/topics Greets, Karst

All, Please can someone help. I have tried everything . I have read about CV's and such for the last few days and I believe I am doing things correctly, The R8247 is version 1 and has 4 ports. These

So, As it is showing no load I think i must connect this to the main track to program it as it hasn't got its own power supply. Showing NO LOAD or this something else? I have to set up CV 513( Cv1) to

Hi, Tried and failed to use the service mode on the programming track. I have read the old manual and watched a? few old youtube videos and it says to put 513 in the CV box. What do I put in the

When using the Programming Track ==> *Service Mode* is the only one. ( and the only onde that the R8247?supports )

All, I have the V1 version which I suspect has a lot less functionlity of the V2 in the manual above. Being a total novice with this and not understanding the basic premise I am a bit stumped. So I

Direct Link to the manual: https://support.hornby.com/hc/en-gb/article_attachments/360015928380

Hi, From the manual:

Should say they CAN'T learn....

Hi, Does anyone know if I can program old V1 R8247 hornby decoders with the new Yamorc upgrade from DR5000. I understand they can " learn" so have to be put on program track and done one at a time.

I went to try the download, it failed because the .exe file is not readable by Mac (error code text:?You can’t open the application “YD_Config-build-59.exe” because Microsoft Windows

Does the Mac M2 run Windows programs? If it does then great, if not you need Parallels or dual boot. Many Thanks Iain Morrison https://wimorrison.com/

Thanks Karst, I sure hope it is a stable, and compliant, way of running the new and improved DR5000.? I may not have had the programming downloaded on this Mac M2 yet...? I'll try and see what does

Sorry Don, but I don't quite get it. ==> You have a DR5000 installed, You are using a Mac.. So you have the DR5000 Software visible and running. ==> Then installing the YD7001 is absolutely not even

Iain: I had forgotten the naming culture once the YD9401 was installed on a DR5000. I was afraid Windows may come into play, but I had hoped just staying within the Mac environment would save me a lot

I refer you to my last response – a DR5000 becomes a YD7001 once you have installed the YD9401 ? Iain Morrison <https://wimorrison.com> https://wimorrison.com Sent: 02 February 2024

Good joke Karst, alas I was not asking to install the actual chip into a Mac, just how to connect to the revised DR5000 Command Station that has that YD9401 chip installed...? How do I connect the