All,
Please can someone help. I have tried everything . I have read about CV's and such for the last few days and I believe I am doing things correctly, The R8247 is version 1 and has 4 ports. These are the steps I am following on the screen shot previously shown. Set to service and the accessory decoder? is connected to the programming track.
CV33 to 0 as I want it to drive solenoids
CV513 change to value of 33 ( this is the block that of 33-36) that i want it to be.
All it comes up with is NO LOAD. Does the R8247 need its own power supply when being programmed?
Is it safe to connect the YD7001 to R8247 and the main?
Is the power too high for the programming track? 19V??
Should it connected to the main track?
I have tried to change it with JMRI single CV programmer and the YD7001 with No luck . I have tried? all kinds to combos with no luck. I am learning about the systems slowly but I am stuck as I believe I missing something simple out.
Just can't see it
Please help
