All,
I have the V1 version which I suspect has a lot less functionlity of the V2 in the manual above. Being a total novice with this and not understanding the basic premise I am a bit stumped.
So I have connected a peco point to the R8247 and connected the R8247 to the programming track.
I have 3 options service , decoder? or accessory . POM which one?
Address? is it 9999 ?
Cv number ? Is the number I start at ?
Bit? not sure what this ?
Please help as I have worked through today sorting out the Yamorc? YD7001 from being a DR5000 and it works fine , train running all good. I even have a pre programmed R8247 numbered 1-4 and that works. I just dont know how to get the new ones to program.
Please can someone tell me what numbers to put in the boxes please or am I completely wrong.
Gordon
