开云体育

any idea what the solution is. I've tried different power supplies. End of bus resistors from DCC concepts. Why do they work perfectly with the ecos, but within 20 minutes coupled to the DR5000 they

It happens with other systems also Many Thanks Iain Morrison https://wimorrison.com/ [email protected]> wrote:

just wondering is the yd7010 much different to the DR500/YD9401 a i was thinking would using the yd7010 would solve my problem with the cobalts losing their addresses as this problem only occurs when

As long as you motors or wagons are drawing more than 2mA the you will have zero issues, especially given that the YD6016xx is sensitive to less than 2mA. If the wagons do not have anything drawing

Good afternon I was wondering if anyone had an experience using the YD6016ES-CS detecting N gauge rolling stock and the reliability? Many Thanks

I have a Kato double crossover T-Trak module with I use a 9 volt battery to run it with a dpdt monetary switch. what you might want to try is powder graphite into the switch it self to help over come

There are variations with these modules including operating voltage and trigger - many are just Lo others are either Hi or Lo by jumper. Note you need to set the trigger source jumper to use either

Could you go into a little more detail on how you wire up those modules. I bought a 8 relay module thinking this would work, but I can't seem to figure out how to wire it given the switched output of

Not use it, see the answer to your ticket !!

Hello, ?I installed YD9401 to my DR5000. ?Upgraded both DR5000 side Atmel FW and YD9401 ESP32 firmware, config program version YD_Config-build-72.exe. WWW server doesn't work. ?The first page

Max 5 per YD6016LN

Not certain, but you could add a second YD6016LN-CS which you connect via Loconet and split the YD6016ES-CS across the pair of them. Sent: 07 February 2025 15:45 To:

yes but how many S88s can you put onto 1 loconet device

Best bet would be to but a YD6016LN-CS and connect it to the LocoNet on the Z21 black. You connect the ES modules into the LN Module Many Thanks Iain

hello all I'm thinking of buying a Z21 black but can I use my 12 S88s with the Z21 as they are all coupled by ethernet cables Does the Z21 have this connection thanks, Alan

Whoopee.. Personally looking at 5 units to go with my 2 Digikeijs DR5088RC units...

Looking forward, need one to complete my block detection. The DR5088RC will still be used, it is working flawlessly with the bias resistors I posted earlier on the forum. Dennis Cherry

Won‘t take long anymore. Dev. is ready, waiting for a production slot ;) (YD6016LN-RC) greets, Karst

I was discussing RailCom and the CS-105 earlier. ?I had not seen anyone post about getting RailCom to work with JMRI Reporters through the Digikeijs DR5088RC and a RR-Circuits LCC-LocoNet Gateway on

I started another thread for the double tap wheel gap activation issue. It was solved by changing the default sensor delay in JMRI. As far as I know you cannot change any detection setting related to