开云体育

Not use it, see the answer to your ticket !!

Hello, ?I installed YD9401 to my DR5000. ?Upgraded both DR5000 side Atmel FW and YD9401 ESP32 firmware, config program version YD_Config-build-72.exe. WWW server doesn't work. ?The first page

Max 5 per YD6016LN

Not certain, but you could add a second YD6016LN-CS which you connect via Loconet and split the YD6016ES-CS across the pair of them. Sent: 07 February 2025 15:45 To:

yes but how many S88s can you put onto 1 loconet device

Best bet would be to but a YD6016LN-CS and connect it to the LocoNet on the Z21 black. You connect the ES modules into the LN Module Many Thanks Iain

hello all I'm thinking of buying a Z21 black but can I use my 12 S88s with the Z21 as they are all coupled by ethernet cables Does the Z21 have this connection thanks, Alan

Whoopee.. Personally looking at 5 units to go with my 2 Digikeijs DR5088RC units...

Looking forward, need one to complete my block detection. The DR5088RC will still be used, it is working flawlessly with the bias resistors I posted earlier on the forum. Dennis Cherry

Won‘t take long anymore. Dev. is ready, waiting for a production slot ;) (YD6016LN-RC) greets, Karst

I was discussing RailCom and the CS-105 earlier. ?I had not seen anyone post about getting RailCom to work with JMRI Reporters through the Digikeijs DR5088RC and a RR-Circuits LCC-LocoNet Gateway on

I started another thread for the double tap wheel gap activation issue. It was solved by changing the default sensor delay in JMRI. As far as I know you cannot change any detection setting related to

Iain Thank you for your response. As you indicated there is no where that I have found to add a delay to prevent these nuisance detections. I am using JMRI so I went to the sensor table/defaults/

In software other than JMRI (or feedbacks other than DR4088xx) this ‘bouncing’ can be cured by increasing the feedback switch-on delay slightly, from 0ms to 25ms, or even 50ms. This creates enough

Thanks in advance. When running a train with multiple cars and a single engine the first block activate as expected when the engine enters it but then when the trailing cars with metal wheels cross

Karst Thanks for this advice I'll upgrade my PSU. Before reading your post I'd actually come to a similar conclusion that it was a power supply issue. I was originally powering two YD8116s together

There lies your problem, our experience is, that the Kato's connected to the YD8008/6940 combo need 15V PSU of about 400mA minimum. Reason: Both YD8008 (1.2V) and YD6940 (0.7) introduce a voltage

I discovered tonight a wiring booboo. When I switched to tortoise switch machines I powered some of the frogs with straight booster power. So when the engine goes over the frog the power is not sensed

Iain I took my advice from the YaMoRC website.? It clearly states that for Kato points you need to use the YD8008 with the YD6940 to convert to 2 wire from 3 wire.? I had originally thought about

Graham, I wonder if the YD8008 are the correct switches to be using with Kato turnouts. The common use for the YD8008 is power hungry solenoids such as the Peco/Seep style that need a real thump