开云体育

Novice here.? So programming the decoder with DecoderPro totally completes the job?? I would not need to go through decoder programing in YD7010 or in the Z21 app?? If so, eliminates redundant

Hi John I did that and it was not in there, thanks any way. Just posted it back to dealer.

Did you check your junk folder.? I had a similar problem.? It turned out I got the code several times but it went into the junk folder and I failed to notice.? My bad but it fooled me for a few

I never received the activation code message despite requesting it, that may be the problem !

Reinstall the drivers by right clicking the installer, and selecting ‘Run as Administrator’.

JMRI does do the actual programming, it only provides a pictorial and textual human interface to your command station. The command station - in your case a YD7010 still does the actual programming and

Karst, thank you for the latest manual!? If I purchase, I will be a very basic user.? I have no legacy dcc equipment to consider.? I want walk around locomotive control using wifi and basic DCC?

Glad to see you managed to RTFM. Shorts. These are not "normal". My system runs very well without them...... If you are getting shorts for any reason, then you need to understand why and then take

Hi Iain I did that 4 times with 2 PCs same result, may have been a faulty YD9401. Now given up on it and going back to my old Digitrax.

It sounds very much like you do not have a connection from the PC to the YD7001. I suggest that you re-install the YD7001 software on you PC and make sure you agree to all the drivers being

Also the built in Throttle did not work.

I managed to get the YD7001 after many hours work to get it on but having tried to connect a Z21 WLNA MAUS to the YD1001 it did not work . All settings were correct but no luck, also tried a Digitrax

Hi, it's there, but still only in German: YD7010.Konfig.de ( http://www.yamorc.de/manuals/YD7010.Konfig.de/index.html )

Demo mode means no USB connection. 1) drivers not/not properly installed 2) USB connector nor fittet "deep" enoug in the DR500's socket 3) USB cable damaged/charge-cable instead of data-cable 4) USB

Any word on a setup manual for YD7010 or quick start guide?? They had been shared earlier but were incomplete due to your writer being hospitalized.

I have looked in the manual since finding this, and I have not found anything regarding short protection. -- Heath @ Human[c]ity http://www.humancity.org ( http://www.humancity.org/

After installing a YD 9401 into my DR5000? and dowloading the config software, I then installed it,? the activation message did not appear. The config software was re installed again still no joy,

Thanks Iain. You've come to the rescue yet again! I'll add it to the files section in the next few days. Matt

I have 4 x DR4018 running 32 x 2 aspect signals with CV47=2. The signals show steady lamps and fade gracefully between the aspects when changed. You may have set the brightness too low and are

Has anyone been able to get the DR4018 to issue a steady Signal light when CV47 is set to 2 ?