开云体育

Unfortunately, this is not a problem that I can live with -- the loco might move 2 inches or so and then stop. I might put up with with once a month or so, but not whenever it moves! Scott

Scott I have 2 x 5013 and I see this fault regularly, at least once a week and I have moved the 5013 to where I can press the reset button easily. Iain Iain Morrison 07767 456746

I've been configuring two new DR5013's and almost had everything right when a new symptom developed -- a locomotive would run into the block for a foot or two, and then the DR5013 would act as if a

Ryan, Thanks! That's... bizarre although they are simplex. Alex wrote:

Any loconet I have even used old ferd’s James Hudson DCC Train Automation newyorknewhavenandhartford@...> wrote: Many Thanks James Hudson DCC Train Automation www.dcctrainautomation.co.uk

Alex, The only known Digitrax throttles that aren't working yet are the (R) throttles when used wirelessly with a UR91. Those may be supported in a future update as the manufacture has some to work

I see on IronPlanetHobbies' website that the DR5000 supports "current" LocoNet throttles. What throttles are considered current, and what is the limitation to supporting older throttles? Alex

Thanks Iain, Ryan. All clear now. Ian

Ian, You can by pass the DR5088RC and go straight to the DR5000. Only one rail needs to be insulated between blocks and then double gapped when next to non DR5088RC blocks. Hope that helps. ? Ryan

I'm looking to use a DR5088RC to report occupancy on some track blocks of a new layout. I understand each such block needs to be wired to an individual Railcom detector output on the DR5088RC.

I've taken part in a modular meeting where the layout was over 50' x 50'. We had a DR5000 running with several multimouse and Z21 phone throttles along with two JMRI withrottles one on a laptop the

I shall have a look at the Merg products? see how I go So much available out there on today's market now. Andrew thanks. Andrew

Thanks Collin Seen the rocrail reply . Just have to wait till August before I can afford the DR5000. Are you on nScale forum at all Andrew

Thanks for the explanation. A user on my future layout would be no more than 12 feet away from a centrally located DR5000. It would have a maximum run of 110 feet in a 12 ft by 24 ft area. Not a large

Thanks James, will do. Regards, John

Hello John It sounds like the H bridge has broken. You should speak to Digikeijs and make a ticket and send back to them for repair. This there policy for returns. They will fix and send direct back

Hi Dennis, yes, checked with 5033 disconnected completely. I think the 5033 is faulty as it now outputs zero volts to the rack. Regards, John

Andrew. The DR4018 is driven from the DCC bus just connect it to the DCC output of your Command Staion (DR5000). Colin.

Have you looked at MERG, you’d need to join their membership but their electronics kits may be cheaper for you to import In to Australia, all depends on your soldering skills and as you make CR

The person I new was from bromley Kent Your right about Train Tech sc1. Looked at SC1 that you have. The price and the exchange rate Made it expensive and import tax . I am in Australia I did