开云体育

@Gio, I wasn't overly careful about taking it apart.? It wasn't difficult.? There are quite a bit of screws of varying length so pay attention which goes where.? The other issue is there are

Tim, can you please share how did you opened the box? There is a lot of screws and I suppose there is a sequence to unscrew... When I handle the radio I hear something inside, going around, something

FCC picture -- Tom AE5NF

I'm really struglling to understand what could be shorted, there appers to be no way of creating a short with the plug :( hope you get lucky repairing it

Could the problem be that some of us are using the wrong size power connector? ?The radios connector is probably a 3 pin and when the barrel of the connector is inserted it disconnects the secondary

On Thu, Aug 19, 2021 at 04:32 AM, DougVL wrote: > > "Shorting out" to what?? If shorting between its own + and -, it would > damage the power supply, not the radio. > What else could be 'shorted'

"Shorting out" to what?? If shorting between its own + and -, it would damage the power supply, not the radio. What else could be 'shorted' when plugging in the power supply? Now, if the power supply

That could be a nice winter project (it's 44° this morning in MT so winter is coming quick!!) I still have a QCX that needs built too.? Anxiously awaiting the x6100. -- 73 Tim KF7VUT

Tim I looked up the FCC certification for the x5105 (older board but should be functionally the same) and in it is pictures of the radio supplied for the test. The schematic was excluded but the

Im pretty sure it was the power connector shorting out as I plugged it in.? Should have never plugged it in under power #1 but #2 the possibility of it shorting should not exist either. -- 73 Tim

One of my activities is 10M AM- usually with restored vintage equipment. But, has anyone tried TX AM mode on the X5105? Reports from locals are either very low? audio or disotrted audio, regardless

Wow, what caused the failure? wrote:

Xiegu might sell you a replacement board.

Removing a knob is not likely to involve opening the case.? Normally, electronic equipment knobs are held onto their shaft either by friction (and just pull off) or by one or two setscrews in the

Hi Jorge, I cannot remember, does the warranty say that opening the case voids the warranty? ?(I am traveling and do not have access to mine.) -- Brian K0FBS

hi all is it possible to easily replace the tuning knob without voiding the warranty ? thanks

It would be nice if Xiegu got to the bottom of this issue and what the fix is. Ive been running my 5105 with the charger on,off,connected and disconnected for 2 years now with no issues. Turn the

You could try https://www.rossmanngroup.com/ They mostly do apple computers, but They are great with surface mount repair

Brian, That repair is beyond my abilities lol.? Sometimes you have to pay the "Idiot Tax" for not paying attention to what you are doing.? ?I'm thinking I'll wait for the new 6100(?) To show up or

Tim, Ouch,that doesn't look like a fun repair.? Thanks for sharing your experience with us we can learn from it. -- Brian K0FBS