开云体育

Hey Harold, I'm no expert on U800 failures, but the two videos I found show different symptoms: https://www.youtube.com/watch?v=WtacH4FGmR0. While the trace is affected, the on-screen-display is not

What SN? A5 SMD or TH ? Beware as hrs can be changes at CAL. Have full serv man for the serial range? Usual drill: 0/ IF A5 is SMD check for corroded SMD cap damages 1/ Check all PSU V/ripple

That was the kind of thing that I was worried about. I do have a parts unit so maybe that could be used if needed. I'm not sure when I will get the chance to dig into it but I very much appreciate

My thoughts are not so much about a HV problem as the infamous U800 horizontal driving chip. Raymond

Harold, It is likely that resistors on the high voltage board are bad. I did post the R numbers and other information for someone recently having focus problems. Mark

I have a nice 2465B that I bought as being fully restored and recapped (I’ve not opened it up yet but have no reason to doubt) that only has about 460 hours on it. I bought it back at the end of

I've temporarily owned such a system a few years ago. The pictures on Tekwiki show that system. But it's not that easy. On top you'll need a terminal and a compatible signature analyzer. And some

The SG505 was designed by the founder of Audio Precision, Bruce Hofer. It is a marvelous signal generator for audio with a THD% level approaching the level of the SYS2722. For those interested there

Sorry, nothing here like that

I looked for one of these a decade or so ago and didn't find anything. DaveD KC0WJN [email protected]> wrote:

Did I put a silly request? Nobody knows what I’m looking for or it’s nowadays so rare that only museums and some collectors keep that equipment closed inside a display case? Thank you for you

Hi Tom, Don't really remember how I did ut. I followed a YouTube video where somebody demonstrated how to make round banners in Word, and took it from there. Sorry, Leo

Made some progress… I finished the artwork for the SC504 knobs. I am going to have some dry transfers made professionally. https://imagetransfers.com/faq.php Or https://www.drytransfer.com/.

The following photos have been uploaded to the Tek user comments ( /g/TekScopes/album?id=301587 ) photo album of the [email protected] group. * IMG_1183.jpg (

Hi all, I have created a new photo album called "Tek User Comments". It's for interesting or amusing comments found written in Tek manuals or as graffiti on equipment. I started it off with a "cry

Morris Odell <vilgotch1@...> added the photo album Tek user comments ( /g/TekScopes/album?id=301587 ) : Comments found scrawled in Tek manuals or graffitied on

Did you try an older version ? TekVisa v2.03 is part of the TDS5000B Firmware download on Tek's website: https://www.tek.com/en/support/software/firmware/tds5000b-series-firmware Win2k is

My TDS5034B boots up with a message that TekVisa is not found. After dismissing the message the scope appears to run normally. Tiring of the nag at bootup I decided to find and install TekVisa. The

Powerpoint might be a better alternative. It lets you place text at whatever angle you like with whatever font you have installed on your computer. I recently constructed the graphics for the meter

Leo, Your artwork looks great. Thanks for posting the Word file you created. I wasn't aware that Word could be used to place the numeral around the circular skirt in that rotational manner. If you can