开云体育

Link ECU and many others are not legal here in CA (offroad only) Stock ECU IS ideal engine control. ECU doesn't make engine run rough Leon

I have had a expensive and negative experience with LINK. That was 6 + yrs ago and they may have changed. Im just saying proceed with caution, ask for successful customers you can call and

This is a 94 ej22 in a 4 speed van. Intermittent hard start, only noticed it when the engine is warm. Engine spins nicely from the starter without any hint of starting. No sputtering, coughing etc,

Call these people. http://www.linkecu.com/ bob

Leon my fuel filter is only 2 years old 3" large canister type, no big deel to swap it out then inspect inside it. I do need to service the fuel gage sender though, it only shows half full ill inspect

My 2.5 was recently cutting out at higher speeds--like you turned the key off for a half second. It would sometimes do the same while accelerating. It ran fine at lower speeds. I finally noticed

Start with simple checks like listen to fuel pump working, strange noises indicate clogged fuel filter, clogged fuel tank or pump itself Engine needs most fuel when accelerating hard, it "stutters"

I have a Subaru 3.3 SVX in my 90 Syncro. Has a Japan Electronic Control Systems computer now (M3 22611 AA681 A18-000 RD4 1712). Any recommendations on a better after market Electronic Control? I have

Bet it is still maf. Cleaning doesn't work.

Hi all im having a issue that im just starting to trouble shoot. 94 ej22 the van stutters and acts like its flooding or running with a choke valve partialy closed. This happens on hard acceleration

06 impreza fly by wire 9k on conversion Just reflashed the ecu Any feedback is appreciated :) [Non-text portions of this message have been removed]

LH(driver's side) rear as when in the Subaru car has a one piece rubber/plastic seal that cpovers the end of the cam. The RH/passenger side (when in the Subaru car is a bolt on aluminum cover, that

Just for some clarification, I was under the impression that the second O2 sensor was only there to determine the effectiveness of the catalytic converter and it had no bearing on air/fuel mixture. I

Grettings I just got done with a little highway trip and now have a p2096 code. Any advice appreciated. Cheers, Mike

There is no seal in the cover and yes you can order the plastic's new from the dealer.

I picked up my rebuilt EJ22 heads from the local machine shop last night and I am putting them back together today. One thing that appears to be missing is the black plastic cover that protects

Hi Tom, I am in the process of installing some rmw stainless steel coolant pipes and reversed heater manifold. I was looking over their design and I don't see a dedicated bypass to the thermostat,

Good morning Dave, You are talking about the classical cooling system issue when installing a Subaru engine. You will need some form of by-pass to ensure engine temperature coolant always gets to the

Hi, I have a basic question about the ej22 into a Westy coolant system: If I shut off the heater in the cabin with the front heater core control valve (which stops the flow of coolant through the

Hi Henry, If your tach was working with your 1.9L WBS engine - the wire for your tach will already be in the Black Junction box in the engine bay. You should be able to just connect it up