开云体育

Issac, it looks like telemdefault= 1 has worked in my situation. Thanks for the suggestion. 73, K5LK

Issac, it looks like telemdefault= 1 has worked in my situation. Thanks for the suggestion. 73, K5LK

Hi Bill, You could try telemdefault= 0 or 1 (0 = completely disable connection announcements) In the rpt.conf file Regards, Izaac VK4IKZ >

Is duplex set to 1 in rpt.conf? Scott N7FGP ________________________________ Sent: Tuesday, May 6, 2025 6:14:31 PM To: [email protected] <[email protected]> Subject: [SHARI] Turn Off Telemetry from

Howdy. I recently upgraded my Shari Node to AllStarLink 3.? I love the additional features, but I can't seem to turn off the telemetry announcing connections from nodes on a connected network. I wish

In your rpt.conf file located in the /etc/asterisk directory you can run the following command: ?nano rpt.conf ?and look for the following to change voice to CW just remove the ; from in front of

Are you using the Hamvoip or ASL3 image?

How can I change my settings from voice ID to CW ID

Technically, archiveaudio saves either at 8 kHz g711 ulaw, raw, with no headers, which it calls PCM, for some reason, or 8 kHz GSM wav. Because GSM is lossy and full of artifacts, I don't use that.

You can convert using the same tool (ffmpeg)... [email protected]> wrote:

I didn’t know my node would record mp3’s. I thought it saved audio in 8 kHZ PCM .wav??

Here's what I use to concatenate recorded nets using the archiveaudio set to PCM, which is actually ulaw. cat /tmp/archive/1234/*.pcm | sox -t raw --channels 1 --rate 8000 -e u-law -

You could try using ffmpeg. e.g., $ ffmpeg -f concat -safe 0 -i list.txt -c copy output.mp3 Where list.txt is: /tmp/foo1.mp3 /tmp/foo2.mp3 . . . /tmp/fooN.mp3 This is running ffmpeg on the command

I'm finally tired of manually enabling recording, after awhile, copying the files out of /tmp and manually joining them in an audio editor. Does anybody have a fairly simple script to do this that

Hi, I have a SHARI SA-818. I believe the SA-818 puts out a 59 Hz STE tone. The handheld I have is a Quansheng UV-5R Plus witch responds to 55 Hz? Is there a way to change the PL reverse burst/DPL

The following items have been updated in the Files area of the [email protected] group. * /ASL3/Kits 4 Hams suggested SHARI settings for ASL3 v1.07.pdf (

The following items have been updated in the Files area of the [email protected] group. * /SHARI PiHat Mod2 52Pi case Documentation/SHARI PiHat (52Pi case with Pi5) Construction Manual - Version

The other alternative is use a smart phone on aprs.fi and have it track its GPS until you can figure it out

About 5-6-8? years ago I bought and used a under $100 APRS? module...It was 1 watt APRS unit that programmed via USB and had a GPS module in it.. The SHARI -none of them have GPS.. It even had a

Ok, I’ll give that a shot, thanks.. The antenna is the one included with the kit from kits4hams, so I didn’t think it would be a problem since others seem to be running the same device and I’ve