开云体育

A Pi Zero only has one real USB port, and one port that looks like a USB port but is only used to power the Pi - that should be the one labeled with "Power" on your device. Karl Heinz - K5KHK

Unless I'm having a brain fart, I remember only ever seeing 2 USB ports on a Pi Zero / Zero 2w... (too lazy to go upstairs and check at 3AM...) Bob KK6RQ

A basic Pi-Star only needs a Pi, an MMVDM board, and a USD card. All it's doing is taking the packet from your radio, modifying the header, and sending it off to the internet. I'm using 2011 PIs that

When you say Support Pi-Star are you referring to using your Shari to access Pi-Star MMDVM Services like DMR or DStar ?.. If so then USRP will allow with DVSwitch the Ability to Utilize your Shari to

That works, Thank you

Change the dash to an underscore in the second line.

I have this info. [events] cop,62,GPIO4:1 = c|t|RPT_RXKEYED cop,62,GPIO4:0 = c|f|RPT-RXKEYED

Please Google MM/DVM hot spot. Sent from Chris's iPhone.

Check the 2 lines you added to rpt.conf to enable the COS LED.? They should be: cop,62,GPIO4:1 = c|t|RPT_RXKEYED cop,62,GPIO4:0 = c|f|RPT_RXKEYED My guess is that they are incorrect

Hello all, I was thinking about using my SHARI to support pi-star. Is this possible? Or do I have to buy a raspberry pi that has an antenna? K6DLC

I have noticed that my yellow COS led stay on. Is normal with ASL 3.0 and if not what needs to be configure that turns the LED off in idle mode? The red COS led comes on only when my SHARI transmit.

Awesome - thanks for the quick response Steve!

Yes - You can power it from any of the ports.? The port labeled POWER has no D+/D- dara connection

Hey Folks, My SHARI PiZero has 4 Micro USB ports but only one of them is labelled 'power' - can I also use the other three to power the device? I'm not overly fond of the Micro USB hole as a power

There's a problem with this approach, though: The sa818, once it sees a PL tone, will send COS high until the carrier drops, not when the PL drops. The result is that the node will still send, though

Here is a probability The repeater outputs a tone when input is being recieved but drops the tone when no input (ie. User not keying up)... my node is connected to my repeter (440) and I do t have an

A few years ago I was going to link two Kenwood TKR series one 750 at one hospital and an 850 at another hospital. I had one SHARI PI 3V and one SHARI PI 3 U and could never get them balanced with the

Guys, you may want to ask these questions over on the repeater-builder group on groups.io. There is a huge amount of expertise over there. Most are going to suggest you connect your Pi running Allstar

I have been trying to do a RF link, also!!! Same results... I would really appreciate some discussion on this from people who have succeeded. We have an Icom repeater that does Analog and D-star, but

Greetings: First of all, a hangtime that long, no matter what you do, is just not optimal for this kind of linking arrangement. Even if you have a repeater with a gated PL, the SHARI doesn't really