开云体育

OK, I'm going to open myself up for criticism and I'll probably get at least 1 "I told you so!" email. Go ahead. I earned it. ? I have a SHARI-Pi set up to transmit on the input of our local VHF

“When it deploys, it will be augmenting our club VHF repeater, W5NNI, on our VHF repeater frequencies.” I hope you mean you will be integrating the Pi into the repeater set up directly, NOT

Thanks for the clarification Shawn. Sorry for all the suspicion.

The node number *is* correct. However, the callsign you have is *not* correct. Our club callsign is W5N *N* I. QRZ link here: https://www.qrz.com/db/W5NNI From where I'm sitting, the Allstarlink site

Mick, The ShariPi is in testing mode, in my house, on a stubby antenna testing with my HT, on low power. When it deploys, it will be augmenting our club VHF repeater, W5NNI, on our VHF repeater

Is that node number correct? That shows W5NI on the Allstarlink site, and when I look up that callsign on QRZ, I get: WILLIAM K HULSE 10904 NE BLACKWELL RD LEES SUMMIT, MO 64086-6624 USA

Since you don't have a call sign, no idea where you are located. But . . . if you are in the USA, you should never put a device on a national calling frequency (such as 146.52 MHz). It is a calling

First, the COS LED is inoperative until you enable it as explained in this document in the Files section of this group

Hello all. I'm new to AllStar and SHARI and the SA-818. I have most of my node (64402) configured. I've watched videos and done reading but this last setting is confusing me. The VHF SHARI-Pi node can

OK, I found I could get back to the Tune Interface CLI from Updating the Node. OK, So that's good. But, i am still trying to get the node to receive. I have no indications of receive activity by the

I have got and set up with identical parameters 2 SA818 hotspots. One works as expected, the other one has very reduced receiver sensitivity. I have done some reseach on the RSSI. The one, which is

I haven't needed any support, but the kit came quickly, the instructions were clear, and my SHARI node has been working flawlessly. It worked the first time I powered the kit on after assembly.

Same experience here. ? Great support. 73 Harv K2PI

Good product, great people! Five stars.

I have ordered 8 kits over the years. Every order was perfect and all kits built perfect from the parts supplied. 100% happy customer. Chip W9OQI [email protected]> wrote:

I can only endorse what Larry has said re Kits4Hams customer service. I have had three or more shipments of Allstar kits past two or three years and have never had an issue with the order, shipping or

Second that! KY4NB [email protected]> wrote:

Hello: This message is about the excellent customer support by the great folks at Kits4Hams. A while back I ordered a SHARI-Pi and there was a problem with the delivery/order.? I advised Kits4Hams

Steve Thanks for the answer and I understand that I don't have to enter the console=serial0,115200 line for Pi5 in cmdline.txt, just modify config.txt by deleting dtoverlay=disable-bt and adding

The second document is correct for ASL3. /g/SHARI/files/ASL3/Kits%204%20Hams%20suggested%20SHARI%20settings%20for%20ASL3%20v1.05.pdf Steve - N8AR