开云体育

I think he used a version after I fixed it :) I fixed it back in May or something like that. New release is getting tested now but as you can guess it takes a long time to test it all :( The bigger

spencer@...> wrote: Hmmmmmm - - - what changed? Regards

it is fixed. it now defaults to 1" and moves 1" i am thrilled as I am using fairly expensive compression router bits and would hate to break one due to a mis jog.

thanks i'll do that. i actually knew that and ad done it before but forgot as i am forgetting a lot of things.

Spencer, The easiest way to switch versions back and forth is to rename directories. I rename Mach4Hobby to something else, like Mach4Hobby_4612, install the dev version from scratch, open two

so what is your suggestion? I downloaded the new beta but would not like to fuck things up. i can probably remember to check the jog increment. i currently jog to home at safe z but can forget :)

there is no gereat hurry i will probably try the new version especially if i can back it out easily. if i have the current version installer do i just need to run it to back out the update? hopefully

We have them on the FTP server but I would like to get the testing done before I get you a new version. But if you want to test it out you are more than welcome to do so. Just know that it is not

Okay, We can look at your positions. Do you have the machine setup on the internet so I can remote in and have a look at it? I would like to see if we are turning on some sort of offset that we didn't

Sending again with subject changed to reflect actual subject matter. _____ Sent: Friday, December 10, 2021 4:20 PM To: [email protected] Subject: Re: [MachCNC] Question about Macros and dialog

Version 2.0.4612 is the current "release" version. It does not contain the fix. The fix Brian refers to has been implemented in the development versions on the FTP site here:

my email is messing up so i don't know if the last email went out. how do i get the corrected version? the one on the site has the same rev number as what i have now. can you send a link to the new

how do i get the revised version? i downloaded the one on the site but it has the same revision number. so i didn't bother ti install it. can you provide a link if it is different from the one on the

Ok thanks but I don’t think it’s the dialog messing up my position’s when I first run the job and the axis’s go off tract to the wrong start position.. I don’t have any dialogs in the

Spencer, I checked the log and I fixed that issue on the following day Revision: 4725 Author: brianb Date: Friday, May 14, 2021 10:25:03 AM Message: Mach4GUI: Update to make sure Inc Jogging is

Gary, After testing it can not be done! We need to do the semaphore :( I can show you how t make your dialog work. We can add a spin lock to wait for the dialog to say that it has shutdown .. If you

I am trying to work on the dialog thing for you still ... One thing at a time. I have enough work to do and I am trying to fit this in for you guys. I think I see the issue with the dialog. We may

the problem with jogging one inch when it says .01" at startup is also a problem any news on this? i have thelatest version and verified the problem.

Ok thanks, but this problem with the toolpath being off center, has become a real problem for me.. I just ram a job this morning.. I started by probing to find the center of part, when centered I

All new to me.. Lets get what we can for data and see what we can find. I think that is the best thing to do. Thanks Brian ______________________________ Brian