开云体育

this is how it is wired.. There are 4 pins on the sensor. Hook the out pin to the printer port pin, hook the 5volt to a 5v source, the common pin to the printer port pin 25 as well as the 0vdc line

For Sale: New in original box Omron 3G3MV-C2022 VFD inverter drive. 230VAC, 3PH and rated at 3HP. The drive accepts both analog and frequency reference signals. Using the step signal from Mach2 you

gee I'm feeling dense.... I've set up the sensor but haven't been able to witness its function in the readouts. I believe it's okay but do I have to re- wire the motors/signals to conform to the

Hi Ross: No matter, NO or NC, you just change the active low setting on the digitize input.. Thanks, Art www.artofcnc.ca

You should be able to invert the signal if needed electronically or electro-mechanically (relay) Greg

Art... Can a normally closed probe switch be used with the digitizer in Mach2? Someone posted an interesting probe switch on another board but it is a normally closed switch.

Dolphin Partmaster Very reasonably priced and an easy learning curve. See http://www.dolphin.zenwebhosting.com/ There are post processors for both Mach2 Mill and Lathe available. -- Steve

Ok then I am having some kind of problem. I cannot get the toggle button to go green when I click on it. I downloaded the latest locked version. Matt

Hi Can anybody suggest a low priced Cam software that is fairly user friendly. thanks Daniel

We need to know how you have the wired normally open or normally closed. The estop will need to be un-checked. Jim

Look on the diagnostics page and note which one is triggering it. Then either check or un-check it. If you use normally closed switches then you need to un-check it. Jim

Look in the configure/input pins and un-check the Estop ( pin 10 ) Jim

still no help Bob??? Robin

Robin, The limit switches are also active high or low. For now, just reverse the state for the one that is giving you a problem. Later when you have limits hooked up you can change the state. Bob

I did that Bob..I am running the sound logic. When it first come up, it says limit switch triggered Robin

Hi All: Version 4.0a is online. It will be moved to 4.0's slot as the new lockdown when its tested. It is also possible to have OEM button calls to the button functions Run, Pause, Rewind...ect so

Robin, Make sure that you are using the Sound Logic XML file. You can download a copy from my web page. Then when starting up Mach2, click on Mach2 not Mach2 Mill. Select the Sound Logic XML

Hello, I am running campbell board and i have the J-21 jumper 1&2 shorted but I still can not clear the E-Stop...what am I missing? Robin

Hi Mike: I'll let the guru's answer this one... You mean other than the two it takes now? Art

from another newbie: disconnect the motors from your machine if possible and keep a hand on the switch. Monte