开云体育

Arcade joysticks will work good for on/off pushbutton type jogging too. Many and cheap on ebay. Thomas Powell http://imageevent.com/tppjr

I am getting ready to remount my drives. Can i mount a 10,000 micro-f capacitor x 80 vdc (which i have) next to each drive (6" away) and skip the 470 micro-f capacitor?(which i don't have) my

You have to have the force feed back hooked up to current sensors, that way you could really jam the tool into the work and feel it hit :-)

of could WOW! great idea! I have DC tachs on my servos that are just hooked up to panel meters calibrated in IPM. While they are impressive to visitors, they don't do much for me any more, but

Really ? didn't know that. Is it in the manual ? Other point : it seems some beginners have never read the mach2 manual. There is 2 reasons according to me : - it's not easy to find on your site

John, If there was enough interest, Jim Cullins could design a breakout board that would use two parallel ports. For now, you can use two board. Bob

Hello, Using two parallel ports seems inevitable for my "gadget" addiction. Are there dual port "breakout boards" available? Or does one just install two boards to handle the port pins? John

If you've ever opened up a pc joystick, you wouldn't go through the bother, Industrial analog joysticks cost $$$$ if you don't need the variable rate, I have a simple circuit that lets you use n.o.

I tried Streamline and own a copy of Corel Trace. Both work but smoothing was a real problem. I had trouble smoothing what needed smoothing but leaving the detail alone. I also use Vector, so I

Art, I tested at cv and full stop. Really doesn't matter, I still loose steps. I then ran it at 50% speed in cv mode and still lost steps. I am not missing alot, just enough to make me question

Hello Art, I am about to register the software and have a few questions Also I need a "crash course" in using the OCX or some "demo Vb code" Best regards peter

Thanks for your help. It works fine Peter and a that gets

I just downloaded R2V software from http://www.algolab.com/ StreamLine is OK , I like the ability to edit the vector file after conversion Peter <crankshaft_sg@y...> wrote: of to all

I'll do some more testing regarding cv or full stop. I have my kernal speed set at 45000, would a lower speed help, hurt or make no diff? Mike Hammel www.fancyfoam.com 1704 Bullard Arkansas City,

At this time I can call most of the procedures without Vb problems. Can somebody tell me what the correct sequence of procedure calls is. (I.E. what needs to be done to initilize properly and what

Hello all, Today is the day I will be energizing the 2 servo's and 1 stepper for the first time, and I am not sure what to expect. I have never seen a system run, let alone build one and run

Mike: Half and full step are known to lose steps more easily when under load. Mach2 does pretty good with them, but not as good as Dos. This is because the pulse stream of Mach2 while very stable

Hi Peter: You can use the MDI method or you can create DRO's to do the job and a button. You simply drop UserDRO's on the screen and a button with a script that gets the DRO's value and does a

Olivier: It will work with no switches, because the lights go green wherever you press ref if you have no switches... Thanks, Art www.artofcnc.ca

It seems that the OCX is working. I use the latest Mach235, Vb6 and Windows XP home edition. The first calls work OK, after a while I get "out of memory", this is probably related to me not using