开云体育

Thanks for the response.? I looked in my Config > Tooltable and it is completely "Empty"

Do you have a 1" tool offset defined for that tool? If so, set it to 0. Look at the height column in Config->tooltable. Les

I have Mach 3 software with a CNC from RouterParts.? I use Vectric Aspire 10.? I can't figure out what my problem is.? Each time I zero the Z axis (manually) and then load a file, my bit offsets by

I found this... https://www.ebay.com/itm/Rosewill-RC-302-Low-Profile-PCI-Card-Single-Parallel-SPP-PS2-EPP-ECP/291286875264 (

I use the “C62” BOB from CNC4PC.com Works great. Chuck

I ran into that exact problem. The second parallel port card I bought doesn't have a driver for WIN-XP and I don’t want to start ordering all sorts that might or might not work. My USB Smooth

I like the PMDX-126 (the CNC router has the older PMDX-125). John Sent: November-27-19 6:30 AM To: [email protected] Subject: Re: [MachCNC] Need more inputs - 2nd Parallel port? Martin, Sorry

This would be my first choice but here in the UK they hit you hard on import tax. Phill

For the ESS, I prefer the MB3 from CNC Room.

You can go to the SmoothStepper website to see the many breakout boards that work splendidly with the SmoothStepper. With that said I installed a SmoothStepper into my old Chinese CNC router system

Martin, Sorry to drop into this discussion I was wondering what Brakeout Board would you consider the best to fit with Smooth stepper. Phill

Go for something like a Smooth Stepper. It will give you the equivalent of 2 parallel ports and is upwardly compatible with later versions of windows so will save you going through all this again when

I ran out of inputs on my C35SR1.2 breakout and read somewhere you can add another parallel card and use the 2 thru 9 pins. My question is, can i use the 2nd port directly and wire my input straight

Awesome thank you very much Dan. Have a blessed Thanksgiving! Dave Hunkele 816-988-6929 ________________________________ Sent: Tuesday, November 26, 2019 11:31:20 AM To: [email protected]

I ran into the subject problem and did a search on Google and a solution came up https://www.machsupport.com/forum/index.php?topic=38269.0 I tried it and it solved the problem. The only issue I had

You said one of your Y axis motors doesn't run. Did you check that slavingis setup in the config file? Dan

I have an Industrial CNC 5x 12 with light use for sale. Contact at ins1234567@...

are you using the same breakout board or interface? have you compared the motor setting from the old and new computer? could you have wrong pin assignments on the new computer? check every setting.

Everything on the Mach3 diagnostics screen looks good as far as I can see. I know everything is good on the machine is good it works on the old computer.

Have you checked for any diagnostics on said stepper motor? Done them? Results? Regards