are you using the same breakout board or interface? have you compared the motor setting from the old and new computer? could you have wrong pin assignments on the new computer? check every setting. something is wrong. check signal polarities etc etc.?
?
?
Best regards, Spencer Chase
67550 Bell Springs Rd.
Garberville, CA 95542 Postal service only.
Laytonville, CA 95454 UPS only.
Spencer@...
Spencer@...
Spencer@...
http://www.spencerserolls.com
http://www.poodlex.com
(425) 791-0309
(707) 223-8212
------ Original Message ------
Sent: 11/21/2019 6:37:28 PM
Subject: Re: [MachCNC] Mach3 One stepper motor won't move
Everything on the Mach3 diagnostics screen looks good as far as I can see. I know everything is good on the machine is good it works on the old computer.
