Do you have a 1" tool offset defined
for that tool? If so, set it to 0. Look at the height column in
Config->tooltable.
Les
On 29/11/2019 14:27, Richard Wize
wrote:
toggle quoted message
Show quoted text
I have Mach 3
software with a CNC from RouterParts.? I use Vectric Aspire 10.? I
can't figure out what my problem is.? Each time I zero the Z axis
(manually) and then load a file, my bit offsets by 1".?? As an
example if the bit is at a Z height of 1.800, with the file
loaded, when I go to "Start Cycle" the bit raises another inch and
proceeds to attempt to run the cycle 1" above my material.? If I
then hit reset, close the file, re load the same file & re
zero the Z axis (manually), and then start cycle again, the file
runs correctly and the bit is OK.?? I have also had the problem
where the bit lowers 1" from the 1.800 height and then proceeds to
DIG into the wood project (I now know better and watch with my
kill switch every time before this has a chance to happen).?? Any
ideas what is causing this behavior?? Its very frustrating to have
to re zero 2x for every file.? Thanks,? Rick Wize
