开云体育

Which branch of MARS is most active nowadays? Army MARS? Navy MARS? Air Force MARS? Seabee MARS? I didn’t realize there were still so many active MARS volunteers these days.

That’s still on my to do list. So wait, even though the mod would be carried out by a factory trained tech (right?) it would still void its Warranty? That would make it pointless no? Might as well

I just talked to the service center in NV, the guy who picked up said it's usually a good idea to wait until the 1 year warranty is over as doing the MARs mod will void the warranty. He also mentioned

The radio will charge with the excess current, and the voltage supplied to the radio will be a max of 13.8 (I am not totally sure about that point but I think I am right). The Li ion batteries will

"If I plug power into the BP500 and run the radio at the same time. The radio will operate and the BP500 will charge with any excess current." That was supposed to be a question, not a statement.

Hi Guys n Gals (I hope that doesn't offend) Here's a question I have been wanting to ask and assuming I ever see the BP500 I ordered in April. Assuming the BP500 is attached to the radio: If I plug

I have just tested the voltages on my battieries and have the following results. Before charging having been used one cell I noticed had a voltage lower than all the others. It was 4.027 volts when

From BP500 manual:

Thanks, team, for the update.? I had read a very early BP-500 English manual and I recall a warning to not use radio power input with connected battery. My memory could be faulty (just ask my XYL).

The manual that has that info is the BP500 manual...; specifically: bottom half of page number nine......SO, just make sure that the BP500 itself does not have ANY leds illuminated (located under the

Andrey, I'm not sure that the English version of the operating manual (v1.12.04) has included that info yet. The BP-500 is not mentioned. No doubt it will be in the next update.

Here's my setup for WSJT-X with digirig: Chuck w8mqw

That's correct behavior. You have to use external power directly to the tx500 in order to update the fw. And it's written in the latest user manual. And there's is no need to disconnect BP500 from

Digirig makes a unit set up specifically for the TX500, with specific cables to go with it. I bought it when I got my TX500 a while back and they work perfectly together. I know some HAMs hate the

Did you check windows/Linux audio control? Sounds like it’s a bit low. Click tune in WSJX and slowly move the playback level slider until you have about 10W PO. Also put the power slider in the app

Did more testing this morning. Running WSJT-X direct to DigiRig Mobile as Com3 with CAT control verified and have both RX and TX audio linked.? As before I can see beautiful RX audio on the WSJT-X

With the BP-500 installed I was not able to load the latest firmware file.? The BP-500 would power off while the TX-500 was waiting for or even just starting to upload the firmware. I suspect the

P.S......Another "mistake" was that my unit came without the paper manual or warrantee card, but the inner box was sealed with the lab599 sticker "unmolested"...(..In fact other than a label on the

Ah hem; please let me be VERY specific: The "pin blocks" on my BP500 do NOT stick out at all. (In fact one side is recessed.) "Baab" w9ya to activate the BP500. And it's described in the manual. and

Hi guys. 1. You need to do it only once after installing/replacing 18650 elements to activate the BP500. And it's described in the manual. 2. I have no probs with that part. TX500 has deepening on