开云体育

Hi Donald, I am interested in the S-meter, the S-meter control pot on the back of the chassis, along with the Response and Selectivity knobs. Let me know what you have available. Regards Kevin M -

Using the Duncan Amps power supply designer ( /g/duncanampspsud ) I modeled the factory supply with 866As, with diodes, and with different bleeder and capacitor values. Long story

They are not available. They are reverse rotation. I ordered five caps and no e really work directly. I did find one that does work at tubes and more.com. however it's slightly smaller and will need a

I need the PA load capacitor for the SR-2000. C156 3 section Halli. Part #048-000629. I think someone else had the same need a short time ago. I cannot find the topic in the archives. Hope someone

Hi Rick and readers, Had a little time this AM to study the supply. If I understand the RCA ham tips article:

I think you’re looking for these Steve? [email protected]> wrote:

Hi Donald, Looking for original Antenna Trimmer/ Calib. On/Off knob. All other knobs but these are originals on my SX-100. Let me know if any of these little guys are original/available. Thanks,

*Hi Dan, * It is a SX 62 not a 62A. Wish I could help. Ron WB4OQL

For Sale: Hallicrafters? External S-Meter. This meter does NOT have a Hallicrafters logo anywhere on it. However, it does have the white on black lettering scheme and it is a “backwards-reading”

Love those old mercury rectifiers. I have them in my Loudenboomer and my Invader 2000. So pretty to watch them working in a dark sack. 73 Jim Zellmer / KA0VSL

Dan, The front glass on the SX 62 is also broken. Sorry. Ron WB4OQL

Diving into another SX99 for refurb. Everything looks good externally and it even plays which is a plus. Discovered the shaft for the bandspread is slightly bent. It works....but on a revolution, it

Hi Bob, Yeah, mine had a shorted rectifier filament transformer.? (HV arced to ground at the bottom)?? The transformer still produces the voltage required for 866, 3B24 etc but I think if HV is

Let me know what you want and a small amount for it/them along with a reasonable shipping cost ... If you have a picture of the specific item(s) - that helps nail it for me. Best Donald

The main thing I could use is an output transformer for a 62A as mine is ? bad , it still works, but one plate lead is open ________________________________ Sent: Wednesday, June 5, 2024 9:36 AM To:

73 Tony Anthony W.(Tony) DePrato WA4JQS Extra Since 1962 CQ DX HALL OF FAME #35 HONOR ROLL CW RTTY PHONE #1 MOST WANTED VP8SSI 1992 #1 MOST WANTED 3Y0PI 1994 Founder :South Sandwich Island DX Group

Thanks for tips Rick! Nice job on yours. Working on mine has been delayed by a broken tooth. I'm hoping to play with it by Saturday. Serendipitously picked 15k and 50k 100W resistors at the same

If you're using the original swinging choke input supply, remember that you cannot "test" it unless you have it connected to the amp or you add additional bleeder.. I wouldn't use the amp(for

Ron im looking for the front glass for my 62, mine is all scratched up, Do you have a good one?I tried to contact u off site but mail fsiled twice.

Not a 62A,right? I need an output transformer from a 62A, 0ne side of mine is out, currently using it single ended. ________________________________ Sent: Tuesday, June 4, 2024 8:46 AM To: