|
Locked
Sticky
Message Delays for Members
Please Read: For new members and existing members who lurk in the background and decide to post for the first time, those postings will not appear immediately and that is by design. Posting delays apply only to new members and those who have never posted before. They go to the moderator(s) for approval, before appearing on the site. This is to discourage bogus or inappropriate messages and that is why this site is clean of any spam and attempts by non-members to post material not related to this sites purpose. After one attempt at posting by a new or existing member, and approved by the moderator(s), that delay or approval process no longer applies and postings will appear right away. I hope this explains the delay of some postings and besides, even the moderators get time off every now and then so please be patient. K2WH Bill's QRZ Biography
|
|
a smidgeon off frequency
5
I am trying to get this into the hands of needy folks given their short supply--- 5500mAh Battery for iPhone SE 2016 1st Gen, New 0 Cycle SAFE High-Capacity Lithium Polymer Battery Replacement for iPhone SE Models A1662, A1723, A1724 with Complete Professional Repair Tools Kit: Pentalobe Screwdriver, Triangle opening tool,Tri-point Screwdriver, Phillips screwdriver, Adhesive Strip, Metal Tweezer, Ejection Pin, Suction cup, Spudger/Spreader No abuse, dampness, smoking, pets. NEVER USED------Excellent! Have two complete boxed kits to sell! $20.00 / door to door¡no xtra S/H! see BELOW pix, specs------USPS economy safe ship via NU2W at QRZ or ARRL SEE ALL OTHER QTH NU2W ADS----NO PAYPAL Please! TU and 73 STAY SAFE AND STAY WELL! Respectfully, Thomas K. Lanieri, NU2W NJ DOH Licensed EMT; PHTLS, AMLS, PHPEC Millenium EMS ARC N.E. BioMedical Services ARC N.E. Disaster Cycle Services
|
|
I just updated the following 2 ads on QTH and thought that ops on this server could be the Better caretaker: SEE ATTACHED PIX: A S-76 RECEIVER on top at 46lbs with the right most large microvolt/S-meter glass removed The mechanicals of the meter/indicator are shot. Cosmetically needs work; bottom front case rust, but no internal penetration. Was capable of 538khz thru 34 mhz in its day. MAY need internal work! ALL ORIGINAL All dial tuning/bandspread controls work smoothly as well as other pots, swts, toggles, buttons, hinged TOP No abuse, dampness, smoking, pets. JUST vintage $75.00 BO and S/H safe ground or PICKUP via NU2W at QRZ or ARRL SEE ALL OTHER NU2W ADS----NO PAYPAL! The bottom rig is the HT-37 XMITER at 80 lbs and was capable of 100 watts cw/ssb and 25 am on 10,14,20,40,80... Nice cosmetics.... ALL original components¡.clean and very repairable. All dial tuning/bandspread controls work smoothly as well as other pots, swts, toggles, buttons No abuse, dampness, smoking, pets. JUST vintage $135.00 BO and S/H safe ground or PICKUP via NU2W at QRZ or ARRL SEE ALL OTHER NU2W ADS----NO PAYPAL! ALL offers considered and replied to. TU and 73 STAY SAFE AND STAY WELL! Respectfully, Thomas K. Lanieri, NU2W NJ DOH Licensed EMT; PHTLS, AMLS, PHPEC Millenium EMS ARC N.E. BioMedical Services ARC N.E. Disaster Cycle Services
|
|
I need a Hallicrafters part number 60A225 power/tone switch. That is the same part number for the power/tone switch in the S-40, S-40A, S-40B, S-85, SX-99 and probably several other Hallicrafters sets using the essentially the same tube lineup. It is the SPST switch element that has failed. The front rotary wafer element is still working. Emil, WD4SCZ
|
|
Hallicrafters SR-400 Cyclone Parts for Sale
3
Greetins to the Group: I have the following SR-400 parts for sale. Pictures available upon request. Prices do NOT include shipping from 97367. Thanks for looking. -- Jim T. KB6GM
|
|
Free manuals
7
I have manuals that are free to good home, pick up at Hamvention HT-44 SX-117 Dave KC3AM
|
|
URM-25D STEP ATTENUATOR
7
Does any know who bought Fair Radios stock of step attenuators for the URM-25? Walt Cates, WD0GOF https://wd0gof.com/Hallicrafters A majority of acceptance is not proof of correctness. https://wd0gof.com/bible-study/commentaries/
|
|
|
|
I just posted the following 2 ads on QTH and thought that ops on this server could be the Better solution: SEE ATTACHED PIX: A S-76 RECEIVER on top at 46lbs with the right most large microvolt/S-meter glass removed and the mechanicals of the meter/indicator shot. Cosmetically pretty beat; bottom front case rust, but no internal penetration. Was capable of 538khz thru 34 mhz in its day. will need work! No abuse, dampness, smoking, pets. JUST old $50.00 BO and S/H FEDEX ground or PICKUP via NU2W at QRZ or ARRL SEE ALL OTHER NU2W ADS----NO PAYPAL! The bottom rig is the HT-37 XMITER at 80 lbs and was capable of 100 watts cw/ssb and 25 am on 10,14,20,40,80... Ok/nice cosmetics.... clean and very repairable. All dial tuning/bedspread controls work smoothly as well as other pots, swts, toggles No abuse, dampness, smoking, pets. JUST old $135.00 BO and S/H FEDEX ground or PICKUP via NU2W at QRZ or ARRL SEE ALL OTHER NU2W ADS----NO PAYPAL! ALL offers considered and replied to. TU and 73 STAY SAFE AND STAY WELL! Respectfully, Thomas K. Lanieri, NU2W NJ DOH Licensed EMT; PHTLS, AMLS, PHPEC Millenium EMS ARC N.E. BioMedical Services ARC N.E. Disaster Cycle Services
|
|
need a load cap
3
I have an exceptional SR-400, all it needs is a new pa LOAD cap. I would really like to find an original. Its a nice radio that I would like to keep original. Walt Cates, WD0GOF https://wd0gof.com/Hallicrafters A majority of acceptance is not proof of correctness. https://wd0gof.com/bible-study/commentaries/
|
|
SX 43
Working on a SX 43 and am wondering if others have run into this issue. I have reception on all bands but only when I connect my long wire antenna directly to the RF adjustment pot for the corresponding band. I have not tried to connect my signal generator yet as it¡¯s a little intimidating compared to other simpler radios I¡¯ve aligned. Any suggestions would be appreciated. I have replaced the all the caps including the filers.
|
|
I have seen center post to ground as high as 150 ohms. It only takes 3 to 5 ohms to start causing problems with speed and weight. It has the biggest effect on the timing capacitors. Walt Cates, WD0GOF https://wd0gof.com/Hallicrafters A majority of acceptance is not proof of correctness. https://wd0gof.com/bible-study/commentaries/
|
|
Repair or Restoration Hallicrafters SR-2000 and P-2000
4
Hello,I have a SR-2000 transceiver and power supply that needs restoration. The transceiver is a 2002 series and looks to be original. Any interest or comments and leads would be appreciated. I am a new member.Thanks,Roger DivitoReno,Nevada Sent from AT&T Yahoo Mail on Android
|
|
New P2000 Rear panels
7
I had the rear panel for the P2000 remade. I was missing one. This is the sample artwork on cardboard. I found the closest press board I could find and dropped it off today. They will print me a few extras. If anyone wants one let me know know. I am unsure of cost yet. Just reply with your name and how many you want. Holding this to the original, it is identical. Same exact size, font and data on panel. They did a great Job digitally scanning and cleaning up the writing.
|
|
RCA RF Output Jack
3
Hi, I have a SR-150 which I am refurbishing. The phono (RCA style) RF output jack is somewhat unreliable, even though it looks to be in good condition. Is there an upgrade suggested to replace the jack with another connector? Thanks for any comments or suggestions. Steve N7AQ
|
|
Probably a long shot but I was wondering if anybody here might have a back panel for a P-2000 power supply that they would be willing to part with? 73 Bob WB9RHW
|
|
Manuals free to good home
I have manuals that are free to good home, pick up at Hamvention HT-44 SX-117 Dave KC3AM
|
|
I just updated the following 2 ads on QTH and thought that ops on this server could be the Better caretaker: SEE ATTACHED PIX: A S-76 RECEIVER on top at 46lbs with the right most large microvolt/S-meter glass removed The mechanicals of the meter/indicator are shot. Cosmetically pretty beat; bottom front case rust, but no internal penetration. Was capable of 538khz thru 34 mhz in its day. Will need work! No abuse, dampness, smoking, pets. JUST vintage $75.00 BO and S/H FEDEX ground or PICKUP via NU2W at QRZ or ARRL SEE ALL OTHER NU2W ADS----NO PAYPAL! The bottom rig is the HT-37 XMITER at 80 lbs and was capable of 100 watts cw/ssb and 25 am on 10,14,20,40,80... Nice cosmetics.... ALL original components¡.clean and very repairable. All dial tuning/bandspread controls work smoothly as well as other pots, swts, toggles, buttons No abuse, dampness, smoking, pets. JUST vintage $135.00 BO and S/H FEDEX ground or PICKUP via NU2W at QRZ or ARRL SEE ALL OTHER NU2W ADS----NO PAYPAL! ALL offers considered and replied to. TU and 73 STAY SAFE AND STAY WELL! Respectfully, Thomas K. Lanieri, NU2W NJ DOH Licensed EMT; PHTLS, AMLS, PHPEC Millenium EMS ARC N.E. BioMedical Services ARC N.E. Disaster Cycle Services
|
|
HA-1 T.O. Keyer
4
I have had several contacts for help with problems in the HA-1 T.O. KEYER in the past couple months. So, I wrote a test & repair guide for the HA-1. It is on my website, no cost download @ https://wd0gof.com/hallicrafters-radio/repair-manuals/ 73 Walt Cates, WD0GOF https://wd0gof.com/Hallicrafters A majority of acceptance is not proof of correctness. https://wd0gof.com/bible-study/commentaries/
|
|
For Sale - Hallicrafters R-274/FRR with speaker
17
Due to health I have to downsize and am selling this Hallicrafters R-274/FRR and the matching speaker. I am asking $550 for the pair. Radio is now working well after I fixed some simple issues. Speaker is at the top of the stack. This unit is heavy, so shipping is not something I want to do. Pickup within two hours of Albuquerque New Mexico will work. Please contact me if you have any questions. Thanks Dwight
|
Image Name
Sat 8:39am
Sat 8:39am