开云体育

I operate an orange C14 with G-11, autoguider and PHD2. The essential remarks were already made. Still some comments. For several years I used on-line guiding, because it worked and I did not want to

yep you got it -- Brian Brian Valente portfolio brianvalentephotography.c

Brian, You seem to be working late - I've just checked and it's after 9pm in CA! Thanks for your very useful input. I wasn't aware that the camera direct connection would be using the ST-4

Hi Paul At the risk of repeating myself, i really encourage you to avoid ST-4 (essentially Thierry's proposal) and instead use pulse guiding. Yes ST-4 can be easier to configure initially, but you

Michael, Thank you for your comprehensive instructions. I'm steadily working through them. I already have an ATEN cable and DB9-to-4 pin RJ, which you might have supplied me over 10 years ago, as I

Thierry, Many thanks for that. My battery is on charge at the moment so I can't test out your suggestion. However, I would have thought that an autoguider would have the capability of sending

IMHO you should connect ZWO guider port to the Gemini then in PHD2 use "On Camera Guiding" .. this way you don't need to seen the Gemini in PHD2...... Thierry

Hi Paul, See the attached PDF describing how to do this. If you need a serial port to the G-1, contact me. Best regards, Michael

Sorry, Brian, my confusion. I'll rectify that when I can find the message in the group. Paul.

Hi Paul Just to clarify, my recommendation was to use pulse guiding, and NOT to use ST-4 -- Brian Brian Valente portfolio brianvalentephotography.com <ht

I have an older (2007) Gemini system running a G-11 mount. I have recently purchased a ZWO ASI120MC-P which I intend using primarily as an autoguider. What I need to know is what I should connect the

I'm hoping some gurus can assist with assisting me with what settings they are using for automated Meridian flips, specifically with Voyager software if possible. I've gone through hours of previous

Thanks Andrew, I will be playing around next clear night and hopefully will have more to add. Will certainly try the guide tab. Howard

I got a chance last night to give the Nudge a try.? How about that, North and South work but East and West gives the timeout error.? However, in the Guide tab there is a similar command and all four

My question concerns the flavour of the month topic namely automated Meriden Flips using acquisition software such as APT and NINA. I have a c2007 G11 with Gemini 1 controller with latest firmware. I

I have the same exact setup.? Forecast here is for clear skies tomorrow and Tuesday night.? I'll give the nudge command a try and report back Andrew

Hoping you can help me with an issue, which I assume is operator error, but I can't track it down. I am using Maxim DL6 with the ASCOM Gemini driver (v.1.0.75) on my Losmandy G-11. Scope connects as

Paul thank you so much? for your time and? work on Gemini ASCOM Driver , I let you know that I am very happy with your work on Gemini driver and make possible Meridian Flip with my simple Gemini1

Robert , we need read messages from groups and I found answer here not long time ago :

Hi Roman, you should upgrade NINA to the v1.11. It has the extra flip detail in it. The max minutes is based on how far pas the meridian you have set the safety limits to. Do you know this value? ?It