开云体育

Hi Howard, First of all, updating the Gemini-1 to the last available version 1.05 is easy to do. Send me your address, privately (see Respond to Sender at the bottom of these emails for a link) and I

Hi Howard, Please share the ASCOM log. Regards, -Paul

I reported an issue with MaxIm DL 6 not nudging properly using the Gemini Telescope ASCOM driver. I would choose "nudge" 10 arcsec and the scope would move way to far. The issue is NOT with MaxIm.

Many thanks, Johan, for offering your experience. I hadn't appreciated the cable fouling issue, but can readily see the benefits of reducing the number of cables. Unfortunately, I'm still waiting for

I operate an orange C14 with G-11, autoguider and PHD2. The essential remarks were already made. Still some comments. For several years I used on-line guiding, because it worked and I did not want to

yep you got it -- Brian Brian Valente portfolio brianvalentephotography.c

Brian, You seem to be working late - I've just checked and it's after 9pm in CA! Thanks for your very useful input. I wasn't aware that the camera direct connection would be using the ST-4

Hi Paul At the risk of repeating myself, i really encourage you to avoid ST-4 (essentially Thierry's proposal) and instead use pulse guiding. Yes ST-4 can be easier to configure initially, but you

Michael, Thank you for your comprehensive instructions. I'm steadily working through them. I already have an ATEN cable and DB9-to-4 pin RJ, which you might have supplied me over 10 years ago, as I

Thierry, Many thanks for that. My battery is on charge at the moment so I can't test out your suggestion. However, I would have thought that an autoguider would have the capability of sending

IMHO you should connect ZWO guider port to the Gemini then in PHD2 use "On Camera Guiding" .. this way you don't need to seen the Gemini in PHD2...... Thierry

Hi Paul, See the attached PDF describing how to do this. If you need a serial port to the G-1, contact me. Best regards, Michael

Sorry, Brian, my confusion. I'll rectify that when I can find the message in the group. Paul.

Hi Paul Just to clarify, my recommendation was to use pulse guiding, and NOT to use ST-4 -- Brian Brian Valente portfolio brianvalentephotography.com <ht

I have an older (2007) Gemini system running a G-11 mount. I have recently purchased a ZWO ASI120MC-P which I intend using primarily as an autoguider. What I need to know is what I should connect the

I'm hoping some gurus can assist with assisting me with what settings they are using for automated Meridian flips, specifically with Voyager software if possible. I've gone through hours of previous

Thanks Andrew, I will be playing around next clear night and hopefully will have more to add. Will certainly try the guide tab. Howard

I got a chance last night to give the Nudge a try.? How about that, North and South work but East and West gives the timeout error.? However, in the Guide tab there is a similar command and all four

My question concerns the flavour of the month topic namely automated Meriden Flips using acquisition software such as APT and NINA. I have a c2007 G11 with Gemini 1 controller with latest firmware. I

I have the same exact setup.? Forecast here is for clear skies tomorrow and Tuesday night.? I'll give the nudge command a try and report back Andrew