开云体育

Phew, I'm off the hook then as my serial port is blown on my Gemini so I can not use GCC Regards Badger

Hi, Well I would say, please try the following: Get a star in a position with which you can do a Meridian Flip. Do an additional align ... then do a Meridian Flip ... after the Meridian Flip center

Hola Rainer I was surprised that you asked that question given your long history with this mount, the short answer is that Gemini does know which star you did a flip on, this is demonstrated by the

Hi, I am sitting in the observatory and just detected in Gemini I the following: Align on a Star > Do a meridian Flip and Gemini I does not remmber on which object the meridian flip was done. So

Ok Tom, I will read it.. Thanks! Miguel Enviado desde mi iPhone

Tom, I have done a ping to the IP of Gemini and I have not received response...? I'm in the Canary Islands... Regards Miguel Enviado desde mi iPhone

Miguel and Andrew. The default on the Gemini is DHCP after programming the flash memory of the processor. But after 4 seconds, it defaults to static with an address of 192.168.0.111 If his computer

Miguel Angel Pérez Hernández wrote: If the Ethernet port you are using on your PC is gigabit, you do not need a crossover cable. Gigabit ports must, and some 100Mb ports can, do automatic

Miguel I have posted an troubleshooting guide in the files section. Maybe it will help. It is just a ruff draft. Tom

Hi All I posted my first attempt at writing a manual method of programming both the SD_card in the main Gemini 2 unit and also the Hand controller. It really needs some pictures to go along with, but

Miguel So if I understand correctly you do not have anything displaying on your hand controller? If this is true, then you are going to have to take your Hand controller apart and program put the

I forgot it! I?m trying to connect to the Gemini using a cross-over ethernet cable, but I can not connect to the IP 192.168.0.111. I have configured Windws connection to static IP 192.168.0.110,

Hallo everybody, I have redone the SD Card for MainBoard exactly as is showed on the Files section on the group and with the advices of Tom, thanks again Tom.. Now, I have found the next: After

Thank you very much Tom, I will try and let you know! Regards! Enviado desde mi iPhone

Miguel PS You could also unzip the latest gemhc.bin file, and put it in the HCFirmware directory of the SDCard before putting it back into the Gemini main unit. If you do, then unplug the Hand

Miguel Yes. Upzip the SDCard.zip file and put the unzipped directories/file on the card. If your zip program is like mine, it does not do empty directories, which HCFirmware is empty. You might

Thanks Tom, If I format the SD and redo it as is on the Files section of the group, is it correct? Thanks! Miguel Enviado desde mi iPhone

Miguel The folders are correct, The GemHC.bin file should not be at the root, but under HCFirmware, and then only until the system uploads it to the hand-controller, then that sub-directory should be

Hallo everybody, hallo Russell. I have loosen the screws that hold the plastic cover of the hand controller, and now the information on the screen si displayed without problem. Now, the problem is

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the Gemini-II group. File :