Miguel
Tom: this is the
content of the Micro SD:
Folders:
Catalogs
DE
EN
FR
HCFirmware
The folders are correct,
The GemHC.bin file should not be at the root, but
under HCFirmware, and then only until the system
uploads it to the hand-controller, then that
sub-directory should be blank,
The files are not.
The only files that possibly should be at the root
before flashing are:
NewGem.bin? or HGM_Gem2.bin??? It should be one of
these but not both. See Variation 2 of programming in
quick start guide for HGM_Gem2.bin explanation.
Gemini.log
After programming.
Gemini.log
Either Cur_Gem.bin or Cur_Gem2.bin according to which
method and file name you used to program the main
unit.
I use the Variation 2 to do the programming where i
rename NewGem.bin to HGM_Gem2.bin before uploading it
to the root of the SDCard. Then all
I have to do is turn the power off then back on.? The
programming takes less than a second after power is
turned back on.
I have noted that the content of the folder
in the Files section of the group is
different, please advice to re-do the SD..
Yes you might have to redo the SD card, as at this
time you would have to use serial commands to erase
the GEMHC file that should not be at the
root of the main units SDCard.
PS: I have fear to
open? the HC... any advice.. I have tried
but it seems that it can not be opened
completely...
If you do not feel like you cannot do this without
damaging the Hand controller, then please do not do
it.? You do this at your own risk.
Please see the Disassembly warning document in the
files section.? The gasket can provide a lot of
sticking between the LCD and top plastic cover.
You might have to use more pressure to get the top
cover off.? Also remove the 4?? screws completely.?
Make sure you keep pushing on the
LCD screen down while trying to pry the top cover
off.?? I do this by pressing the LCD down (LCD facing
up) with the HC placed on a mouse pad
or cloth.? Mine sticks so bad that I have had to pry
it with a small screwdriver at the slot where the top
and bottom join on the sides or end, to
get it started.? I kind of now wished I had not
installed the Gasket, as my unit came without? one,
and I later added it myself.? I again say, if you do
not feel
like you cannot do this without damaging the Hand
controller, then please do not do it.? You do this at
your own risk.? Take it to your dealer.
Tom Hilton
