开云体育

Could I ask you to please sign your messages so that we know how to properly address you. Also please crop your messages by typeing your message at the top of the message you are replying to, then

I don't have my Gemini II yet, so I can't visualize everthing you're describing. But you seem to be suggesting arrow / direction symbols on the buttons. My preference is that buttons don't show a

Rex Pec has not been implemented yet in the firmware. Soon we hope. Tom Hilton

Hi, I've been in contact with CCDware about the Gemini 2 and its interface with the PEMPRO PEC correction. The discussion was the following Hi I have the new Gemini 2 Controller and PEMPRO connects to

Should have read The check boxes to reverse the buttons is going to be on a separate screen from where the buttons are. Tom Hilton

The check boxes to reverse the buttons is going to be on a separate screen from where the check boxes is. This is because there is not enough room on the main screen to put the reversal check boxes,

In the future René will be working on changing the hand controller code to make some improvements. One of them is to add the capability of reversing the direction of the RA or DEC buttons on the

-82:21 27:44

Brand new to Gemini. Just received G-11 Gemini 2 yesterday. Have yet to fire it up as I have a dec axis CW issue. When entering location data, do you use minutes or decimal notation? My longitude is

Hallo again, I have been this morning on the observatory.. I checked the Gemini 2.. all it is good.. The problem: My partner connected the HC on the Serial Port 1.. I connected in the SP2.. and all it

I will have to check that out - sounds like the easiest solution to me! Lee

Ok Tom...thanks I will chek it tomorrow.. and let you know Regards Miguel Angel Pérez Hernández Alpha Cygni S.L. www.alphacygni.com c/ San Agustín, 23 38410 - Los Realejos S.C. de Tenerife Islas

PS There may be some confusion here, as the Faceplate on the Gemini 2 is labeled Serial Port 1, Graphics HC and Serial Port 2, Graphics HC, while the Web interface refers to them as Serial port 0 and

Miguel You set the baud rates for the serial ports using the Web inteface. Goto the Serial link and set serial port 1 to 57600 baud. Tom Hilton

Hallo René, It is the same Gemini and Hand Control that I reprogrammed the last Friday. I checked it again on Saturday morning, and all worked good.. I?m not very sure what happened, I will check it

Hallo Miguel, Can you tell us what has been done? Is it the same Gemini board? Is the correct port used, its baud rate for the HC (57k) set, ... The SD card should be freshly formatted at the start.

Hallo everybody, Last night I received a called from one partner in the Observatory asking me for a problem with the Gemini 2... Hand Control showing "Connecting to Gemini".. I don?t understand

lroehrdanz wrote: If the laptop Ethernet is Gigabit, you do not need a crossover cable. Gigabit does autosensing on cable connections. I have a notebook with 100Mb connected to a gigabit switch with a

Tom it can depending on the type of router and if it does bridging/repeating. most do not. but some do. I have a Buffalo Router that does. I bought it for that reason (actually in my case for the

Hi Paul, Thanks. saludos Rainer