Re: Latitude bug.. fixed??
|
Hallo ¸é±ð²Ô¨¦, It is the same Gemini and Hand Control that I reprogrammed the last Friday. I checked it again on Saturday morning, and all worked good.. I?m not very sure what happened, I will check it tomorrow. About the baud rate for the HC (57k) set... How can I check this?.. But, this is not a value that can change momentarily, not?.. I try to say, if I checked it and it worked ... then it has to work if any changes has been done?.. Regards ? Miguel Angel P¨¦rez Hern¨¢ndez
Alpha Cygni S.L.
c/ San Agust¨ªn, 23
38410 - Los Realejos
S.C. de
Tenerife
Islas Canarias - Espa?a
Tlf/fax: 0034 922 34 30 38
? ?nete a Betacygni, la trastienda: ?
De: Rene Goerlich
Para:
Gemini-II@...
Enviado: jue,24 febrero, 2011 18:25
Asunto: Re: [Gemini-II] Latitude bug.. fixed??
?
Hallo Miguel,
Last
night I received a called from one partner in the Observatory asking me
for a problem with the Gemini 2... Hand Control showing "Connecting to
Gemini".. I don?t understand because after reprogramation the Gemini
worked propperly, I tested it several times and it looked good..
Tomorrow I will try to confirm that my partner did a propper
connection... but if really exists this problem again.. I won?t
understand it..
Can you tell us what has been done? Is it the same Gemini board? Is the
correct port used, its baud rate for the HC (57k) set, ...
As
prevention I will do a new SD ram with the firmware for the Main Board,
as I did it last week.. The only reason that I would understand is a
problem with the SD.. any advice?
The SD card should be freshly formatted at the start.
¸é±ð²Ô¨¦,
have you fixed the problem with the "latitude sign"..
Yes, and added a lot of things. Alas, I was busy all day, I'm just back
at the PC. I'll have to remove some tiny bugs, most is already working
fine.
¸é±ð²Ô¨¦
|
