Hallo Miguel,
Last
night I received a called from one partner in the Observatory asking me
for a problem with the Gemini 2... Hand Control showing "Connecting to
Gemini".. I don?t understand because after reprogramation the Gemini
worked propperly, I tested it several times and it looked good..
Tomorrow I will try to confirm that my partner did a propper
connection... but if really exists this problem again.. I won?t
understand it..
Can you tell us what has been done? Is it the same Gemini board? Is the
correct port used, its baud rate for the HC (57k) set, ...
As
prevention I will do a new SD ram with the firmware for the Main Board,
as I did it last week.. The only reason that I would understand is a
problem with the SD.. any advice?
The SD card should be freshly formatted at the start.
¸é±ð²Ô¨¦,
have you fixed the problem with the "latitude sign"..
Yes, and added a lot of things. Alas, I was busy all day, I'm just back
at the PC. I'll have to remove some tiny bugs, most is already working
fine.
¸é±ð²Ô¨¦
