开云体育

I figured it out.? Had it on split frequency

Not sure what function or what button I clicked but when I PTT the band switches.? How do I stop this from happening? Thank you, Pat

Each connector in the molex connector is only rated for 15a so to make the 20a requirement of the 857 yausu paralleled the connections. On low continuous current modes like SSB you should be fine.

One issue with the "Molex" connector is that is is not a Molex connector. It is a Japan Standard 6 pin power plug and there is a difference in the sizes of the connecting pins. This is one reason

i use power pole connectors based on what you said…i think the short answer is the oem connectors double the connections for backup. thanks jack w4grj

If you are referring to common molex used to power hard drives ... you are pushing it. Over the years there have been issues with "standard? " Yaesu power connector - not making sufficient contact

"Molex" connectors were originally used for connection of equipment such as low-voltage DC connections like rack power supplies, which would normally plug and unplug only when the unit needed to be

I have a molex power cord with just one pos and neg wire connected. The oem connector ( which i cannot find) has two pins to pos and two to neg Mine seems to work o.k. but wondering if anyone knows of

Also try adding a random length of coax to your feedline (10-15 ft.). Also try looping the end of the feedline around a toriod core...? ?And don't forget the microphone cable..? I've solved RF

Try a ground wire between the computer and the radios. I had a problem until I tied them together and the radios to ground.

Thank you Barron But I am using it. Almost all the cable (Data and Power) is using looped beads or single beads. Still it is troubling. Any will carry on investigating. Hope can be done with it. 73s

It has little to do with the SWR seen by the transceiver, but rather the RF in the shack. A few ferrites on the USB cable(s) and the CAT may help. If you have one that you can make several loops

Ron, You were spot on!? It was the chip fuse.? ?I had terrific service from Yaesu in Los Angeles. Sent it in on July 19 and got it back fixed on August 16th.? ?VERY reasonably priced as well.

Hai all When I tune my 857 and with my LDG 1000 pro-II, ant. tuner on 40 mts (Only 40 mts) *the software gets disconnected*. The dig. interface used is Link-5 (BY make) with CH340 driver. I feel may

You can use my yc1-bt to do? a Bluetooth link from your radio... Take a look at www.ve2dx.com -- 73 Richard VE2DX Lead Designer and President WWW.VE2DX.COM ( /g/ft817/WWW.VE2DX.COM )

I use the DigiRig, works great! KB8VUC

Greetings, You may look into the Yaesu SCU-17.? It is compatible with the FT-8x7 series radios and provides both CAT control and sound card interface for FT8 and other data modes. I've been using it

Thanks Troy, Haven’t had that problem (yet) but appreciate the info. Regards Albert VK3BQO Sent: Tuesday, 16 August 2022 6:40 AM To: [email protected] Subject: Resolution: Re: [FT-857] menu 59

I used: Mark V. Dunkle, KJ6ZWL BlueMax49ers eBay & Amazon Seller DunkleM@... Cell (408) 832-2954 1385 McBain Ave. Campbell, CA 95008-0725 USA Top Rated Plus FTDI Chip ? USB Programming Cables

Thanks Troy for the feedback. 73 de Thierry, F4GVO