开云体育

You don't RX anything on FT7800 when you Tx your Handheld? Did you enable tones on FT7800. Your FT7800 should Rx a signal from your handy and pass it through DINAH and made your Node TX.

2nd thought, is there a packet menu that needs to be set to enable the IO on the the 6 pin mini din? I believe it needs to be set to 1200.Steve VK2ARS

Hi Craig, not a CTCSS mis-match between the HT and the 7800?First thing that came to mind.Steve VK2ARS

If you call Dinah they will help you with your specific radio. If anything else I'll try to help.

Be sure that the miniDIN connector is fully seated into the jack on the FT8800.? I think I had to shave off some of the overmold on the connector on the cable when I set up my DINAH/FT-8800 node.

Hello DINAH users. I have just purchased a DINAH - C (USBC) model. I am trying to setup the DINAH with my Raspberry Pi4B. It is receiving and the radio is then transmitting from a node that it's

HI, May I join in.. Just received my DINAH-C and like this chap, I am receiving from Nodes.. But I have no audio going to out.. Option 2.. RX VOICE DISPLAY I have nothing being displayed. Hope you can

HI, May I join in.. Just received my DINAH-C and like this chap, I am receiving from Nodes.. But I have no audio going to out.. Option 2.. RX VOICE DISPLAY I have nothing being displayed. Hope you can

Hello, I am new to this DIINAH thing.? However, I am familiar with Linux.? I have an intel laptop running all the allstar stuff, connected the DINAH to an FT991.? Have the FT991 set up as -RPTR,

I need to be able to use a thumbdv USB , that had no USB connection for that. I need a modified sound fob I can't seem to find such on eBay or anywhere. I have your shari I have tested everything just

Probably not.? The COS and PTT interface is the same but BRIAN has 10K series resistors in the audio connections which are not in DINAH.? Assuming you connect to the same points in the BF888S that

this should work with a BF888 baofang for use with allstar , correct ?? thanks n8dad

My Raspberry went dead. Just ordered a New one. [email protected]> wrote:

The Dinah will not turn on with the pi but it will on any other device, My computer my hot spot but not on the pi, so looks like my pi is dead!

By the way how much are your pi's?

FWIW: Because you are only changing the output pin of the radio through a crossover cable, you shouldn't actually change the radio to 9600 in menu 518, as both output pins are always active. Changing

Did you verify the cable wiring with an ohmmeter? Did you set the speed to 9600 in the TM-V71's menu 518? Also, you do not need a special cable for DINAH to use 9600.? Just cut the trace between JP1

Hi. I have a Dinah and a Kenwood TM-V71A. I have a couple friends with the same set up who have switched DIN plug pins 4 and 5, and are getting flatter/nicer audio as a result. We all ordered the same

Made a bit of a mistake here: I meant to say SQL when I said CSQ. The default on the TM-V71A/E for COS is BUSY, which is essentially just carrier. It can be changed on this radio to SQL, which is more

Greetings: The older Kenwoods have COS logic hard-wired to carrier. With radios like the TM-V71 and TM-G710, you can change this in a menu to CSQ. On the TM-V71A/E, this is done in menu 5-2-0. I have