开云体育

You may want to check the FCC rules,? Linking Via VHF is- or was against the rules. I have not boned up on the FCC rules for about 10 years, but I believe links had to be above 222 mhz and previous

I have a node on a repeater using a remote radio and I set it to duplex=0 that way there is no ID coming from the node and the club repeater folks are happy about that. I also did a noununct setting

I would also add that the node radio will send the repeater ID and courtesy tone down the network. Some nodes don't allow this traffic. Best way is to make the repeater dumb and allow the node to do

Are you running it as a duplex =0? Les Keegan N4LPK

There is a local repeater without Allstar access, and we'd like to enable that without adding anything at the repeater site.? We are trying to set up a VHF rig with a DINAH, so the Allstar audio

Adjust the radio itself.

You set up CTCSS in the radio that DINAH is connected to.? Thr radio combines CTCSS with squelch to create a composite squelch signal.

hi i want to setup a ctcss tone for TX i am using a Dinah node Thanks

https://lonewolfsystem.org/images/supermon%20file%203.pdf

hi all i am trying to change my image on my supermon header looking for info on how to do it

You reprogram the frequency in the radio that DINAH is connected to.

What radio is your Dinah plugged into? For me, it’s a Kenwood TM-V71A, and I just tune the VFO.

Adjust your radio???? ?

Hey just woundering how i would go about changeing my operating freg its 146.550 now i want to change to146.560 thanks

Try wrapping your hand around the USB cable (if not directly plugged into the Pi) or the radio cable leading into the DINAH, for 5-10 minutes and see if your Pi behaves itself.?? I had issues with

My DINAH is causing my pi node to act erratic. It works fine for a while, then sometimes it knocks out the wifi on the pi itself out. I ping the pi and it will be non responsive, if i unplug the

Did you make your own cable to go between the Dinah and the FTM-500? Page 70 of the operating manual, go through the DATA section. You will need to select the DATA BAND. Also set DATA SPEED for 1200

Has anyone used a DINAH with an FTM-500? I have been unable to make it work inbound or outbound.

It has a 6 pin miniDIN packet connection so it should work fine with DINAH.

I have a ft-8100 that I would like to use as an allstar node for my local ham community. I am wondering if the device is compatible with that radio or if I will need to modify anything? Thank you Mike