开云体育

You want to be using CHIRP-next, not legacy CHIRP. Legacy CHIRP hasn't been developed for over a year. With CHIRP-next, access to the debug.log file is as easy as clicking Help in the menu bar and

I am not certain how valid this is, but prolific based cables are famous for not working. Most are counterfeit. The recommended alternative are FTDI based cables. 73 Ralph Ward

To all who responded so far. It's something to do with this Win 10 computer I'm using. The cable and radio, and a legacy version of Chirp, work just fine using my son's Win 10 MS Surface. Same driver

The debug.log should show what the returned echo was (or if there was none). My recommendation would be to open a bug report and include the debug.log. Jim KC9HI

I cannot get my brand new *Yaesu FT-65R* to program using Chirp and the *Yaesu SCU-59* programming cable. I am in Memory mode. Windows 10, Device manager shows – *Prolific PL2303GC USB Serial COM

Apparently not. If the radio supported split tones, then there would be a Cross Mode column and Tone Mode would have a Cross selection. CHIRP can't make a radio do anything that it doesn't

Is it possible in Chirp to have a transmit and separate receive ctcss tone for a frequency?? If so how do I program that?

IMO, just allowing input of frequencies is not really supporting the radio, it is a downgrade from the from the, again in my opinion, previous serviceable version of Chirp, pre-chirp-next. That said,

That is all that is supported for the FT-8900. It is up to the volunteer developer as to how much effort (s)he puts in to supporting a radio and how much of its features are supported. There are no

I have installed the above on Windows 10. When I open an FT-8900 image I have 1 tab: Memories. When I open a 7900 image I have I have Memories, Banks and Settings. Is the 8900 not fully supported yet

hmm. Does Britty use a different package name? I did: dpkg -l | grep -i bri and got nothing that looks like what you are talking about. I'd be happy to have a clean fix like this.

Hi. Using Chirp, can you assign memories to each scan list? I can only seem to do this via the front panel and can't see any option in Chirp to do it.

Yes. It looks like you are wrong. 1. I did a clean install of the latest Linux Mint 2. installed CHIRP-next following the instructions on the Running CHIRP on Linux page 3. logged out and back in to

I copied the NEW software down to? my Linux Mint laptop. 1. I fired up the Chirp program 2. did a dmesg --follow to see what was going on, plugged in the cable, (it said it was attached to

Ok Great, I was just curious if it could be done.

This radio only has a single bank of 200 memories. What you are referring to are the A and B display lines, not "banks". Like most Chinese radios, there is nothing provided in the radio for separating

Did you ever figure this out? Tnx. Bob NE0CQ

The "Power" column works like this. When imported, the value in the CSV will be replaced by the closest match in the radio. So when imported to a UV-82HP which has choices of LOW (1 watt), MID (4

A csv file that I built will be blended with the downloaded images of several different radios. The "Power" column defaults to 50W, but handhelds aren't capable of that much power, of course. I try to

Thank you very much I can't speak to how the Kenwood was programmed for non standard codes we've had them in use at work for at least 10 years so it's lost in the fog of time.? Does anything change