开云体育

Hi Allen, N8ME is another Arduino code for the uBitx v6.? The files can be downloaded from the files section in this 开云体育. Here is the link to the version that I

Evan, quick question. What is the M8MEseries you mention? I haven't seen this prior. Thanks! KI4QCK

Bryce, The potential issue with using the US AM band is that the calibration accuracy is improved at higher frequencies.? An error in the AM band of the US will be multiplied many times for HF

Bryce, Using WWV (W1AW does not transmit on 10MHz) with all the other tones transmitted for time sync can be difficult.??If you are comfortable with the accuracy of your signal generator, you can

I think this might be the way to go: /g/BITX20/message/102615 Bryce, AK4MG

Hi Gary, There are several good mods listed on this website: http://ubitx.net/ I? just finished the recommended uneven power fix for another Ham and was very pleased with the

Wow Mark! I looked at the Raduino design (just for the pico) and it's pretty nice!? I love all your comments in the silkscreen on the board.? That's one of my pet peeves when working with my

Hey guys...just built a ubitx v6 and am so amazed with it. It's power output is a bit low on all bands except 75m where it's 12 watts pep. The others are 2 to 4 watts into a dummy load. It definitely

Test the Zener. It’s a 5.6V unit. Photograph it before you remove it if you’re thinking of doing that so that you don’t reinstall it backwards. Jack, N6LN

I replaced my IRFZ24Ns (my fault) and made some straight key CW contacts with my sBITX V2. I decided to try the keyer and set the drive to zero with the rig connected to a tuned antenna. I practiced

Hank Let us know how that works out. I was concerned that a long clip might break off when inserting the sBITX feet into the holes. -- 73 Bob? KD8CGH

I appear to have been able to tune the BFO using the online tuning aid.? The white noise response matched that in the video.? I also tuned the frequency and was able to pick up FT8 chatter on 7.074

Printed a pair for me but I think I'm going to add to the top "clip" to go the depth of the radio so it can hopefully be picked up in one piece. Hank W6IR

Well, quick update.? I pulled the Si5351 off an Amazon signal generator board. https://www.amazon.com/dp/B08D98LYJS Long story short, I have tuning happening!!? Now I need to go through the

Thank you for all the quick replies!? I wanted to get some hard data before replying. Did you do your scope work on the main board or radunio? ?Check that the Radunio board is properly fitted to

Great addition. Thanks Bob! Jack N6LN

Paul, The other thing to worry about is which screen is selected. My memory is that the 1.2 source code defaults to the 1602LCD in parallel mode.? Make sure that fits your needs. If you like to

Bryce, First of all, I have ordered exactly the same set of 3 Nanos as you, multiple times.? They work fine.? The stock does vary, sometimes they are the old bootloader (have to program them at

Thanks Evan! I wanted the source code to do some mods. I have used the IDE a long time ago and forgot most of it.?? Thanks for the help.? If it doesn't work I will ask for more help.???

Hi Paul, May I ask why you would like the source code rather than using the .hex file that is available on Dr. Lee's GitHub? Another question, have you used the Arduino IDE for other projects?? If