开云体育

I hadn't realized Santa had traded in his sleigh for a yellow cargo van, but must he must have.? I had ordered a uBitx late Saturday or or was it very early Sunday morning.? Did not expect it to get

I ordered mine on Dec 9, shipped with DHL on Dec 12. They tell me it will be delivered tomorrow Dec 15. Wow! August KG7BZ

Michael and all, the product that softens the decal, to make it "snug down" to the surface, is called "Solvaset". Available in hobby shops and, I suspect, at Michaels stores.-- Rich WB2GXM

Where are you?!!!!! Texas - Zimbabwe - Sri Lanka?!!!!!

Thanks!!!!!! Sent from my iPhone

I just loaded a file in the files section titled " Decals.pdf ( /g/BITX20/files/Decals.pdf ) ". It is an except from a document describing one of my projects. It completely describes

Thanks for the info.Something new for me to try.

It was shipped via DHL on the 12th and I got it today the 14th!!!!!! I did a card stock mockup of a front panel design and I can make it fitl? ?The large black circle on the top right is the outline

the picture is for demo only. Notice the arduino board in behind is not connected to anything but the display. I suspect Al is using the default firmware for display purposes only so missing all the

Try Googling "Laser Waterslide decal paper". ? It sounds like what you were using for labelling instrumentation was more like "Letraset" or something similar. ?Waterslide decals are more typically

I would have assumed it was mechanical. Me, too, since most optical encoders would cost at least 10% of the ?BITX's retail price. However, another poster pointed out that you can "convert" a

Jack W8TEE wrote... It's a "bunch of wires" but I'm glad to see you have it fired up and working. I just received a confirmation that mine has shipped, but I didn't go for DHL so I'm sure it will be a

El 14 dic. 2017 1:22 PM, "Michael Hagen" <motdog@...> escribió: > I would like to know more about the Decals. I used to make lots of Test > Equipment. > > We bought packages of rub on decals

Those are some cool knobs.

1.? You print them. 2.? You coat them after application with very light layers of clear spray paint, like Krylon. 3.? Laser has the advantage of being waterproof, so it's likely a little more

Craig Extra space was made to allow front panel controls to avoid the 8-pin connector. Since this is a temporary enclosure I added extra space to make it easier to play with some near future

I would like to know more about the Decals.? I used to make lots of Test Equipment. We bought packages of rub on decals from the electronics parts store.? They had numbers letters, and common words.

I'd just configure the relays in the uBitx for 80m (the 80m LPF will pass 160m too), then add an external LPF when using the uBitx for 160m. If you have a separate 160m antenna, there is no loss in

?Arvo: every mic is different but there are common themes. Lots of mics these days use electret elements which require a load resistor and DC voltage (the Bitx has a resistor and DC source) --- but

David, Thanks for the info. The Bluetooth LE stack portion of the EPS32S might be the way to go. And your i2c “gap” approach is what I used on the ten-tec in the vid. But controlling from a