开云体育

Cringe

You would need an RG45 case mount female connector and would also have to wire it for ptt/mic etc in the case. Just me but I wouldn't use it for the bitx.

I’m thinking of replacing the Radino Arduino with the EPS-32S chip (WiFi and Bluetooth) for memory and memory group creation, editing and recall. The control rf is passed through seams in your uBitx

Banggood has the case shown in post 35500 for $10: Excellway? EF01 Electronic Plastic Shell Cartridge Handle Project Case Desk Instrument 200x175x70mm | | | | $ 9.99 | | | | | | | Excellway? EF01

Google "clear printable sticker paper."

That looks good. What do you plan for the open space (or was that done for front-panel control space)? I’m considering building a linear power supply or perhaps a LiIon pack into the box.

Hi All, I have a uBITX on order. I want to install AGC. In anticipation, I modeled Farhan's suggested AGC circuit from 13/11/16. However, in the model it appears the gate voltage to the FET never gets

Only another lpf and code changes required? Is there a spare uc pin to control some relays? Are there other considerations? Regards Simon VK3ELH

I am planning to get this case for my uBitx. https://www.ebay.co.uk/itm/HF-1-9-ABS-Plastic-Enclosure-Connection-Box-Project-case-Instrument-Shell-Cover-/301496955397

Yes. I would also like to know how you put the lettering on the plastic panel Michael Babineau ( /g/BITX20/profile/@ve3wmb ).

parametric case designer for 3D printing https://www.thingiverse.com/thing:1264391

The 40m BITX had a case that could be 3D printed. I haven’t seen the specs of the uBITX compared to the 40m version though. Matt Sent from my iPhone 7

I am building the BITX20 with the kit from Sunil.? I glued two T37-6 cores together and wound 40 turns.? The inductance measures 10.06 uH.? What should be the correct inductance for the VFO?? (The

Thanks Sarma for kindly publishing the datasheet.? However, I had already looked it up and my problem was in my interpretation of it.? I can follow vacuum tube and IC diagrams (I know which way

I would say whatever is smallest, sma? - if you're inclung that as an option coz you can always make the hole bigger. But some merit to a proper bnc hole which is supposed to be noncircular.

Awesome! Thats pretty quick delivery. Looking forward to mine arriving soon as Ive got some holidays coming up and time to spend putting it together. Hoping to take it portable to activate ?few

*is it possible to connect Kenwood PTT mic which am using for TM281 to bitx / ubitx ? Is possible kindly tell me how to connect it .. * DE Vimal

Hi, I am doing the same on ubitx backing off the RV1 preset , to drive 5 watts into external Linear amp Farhan can I have Drive pot mounted suitably on the rear panel, as it would make it easier to

Excellent job on that front panel Michael. My friend has the same enclosure. Two questions - 1) - how did you get the lettering on the panel, and, 2) - can the lettering be in white? My bitx40 box is

guys, drop a mail to hfsignals@..., they will reply back. - f