开云体育

Hello, I’m trailing designing a new PCB from M0HYT’s Ubitx. The copper side where the components were (No SMD, only components with through holes) had few tracks but a maximumground. The rear

It is very strange to call "AGC" a simple "AUTOMATIC ATTENUATOR"! The following considerations are derived from my direct experience of assembling an ND6T circuit (KIT-PROJET module) on a ?BITX-V6

Man, can Don draw or what? Beautiful! Jack, W8TEE

Sorry! Wrong link! The right one is http://www.nd6t.com/uBITX/AGC.htm

http://www.nd6t.com/bitx/AGC.htm 73 de PU1OWL Rafael

I'll be heading up to OK in a few weeks but it will be daytime so I doubt I'll see much action.? I am going to try to activate? for POTA while I am there so we'll see how that goes.

Good Stuff! Me and some buddies took a open trailer of motorcycles from Pennsylvania to Florida and back one weekend and I brought the bitx40 along. I too used a 40m ham stick with a "jaws of life"

Hi Jim, If no has beat me I'll take it. 73, Dan (W3DF)

Darn, was just about to bite. Now I'll have to fall back on whatever firmware update I can do to my v3 that permits CAT operation. Or get a new v6 and do what you've done to it... Oh well... Bet I

Wow, that was fast -- THIS HAS BEEN SOLD already. Thank for the interest, Jim, W0EB

I have a uBITX V6 for sale that was purchased as the full kit with the factory case.? It was used for testing of the TSW (Triumvirate Skonk Worx) group's Teensy 4.1 Raduino which highly improved the

Mornin' Farhan: I, too, don't want to sound pushy on connector locations. It's just a preference. One thing Al and I didn't think about when we started bread boarding the T41 was the location of the

Definitely also looking forward to the kit. Owen Vk5kov

Sorry did not mean to sound pushy, well done Look forward to kit when ready Thank you John Graham ZL4RO Sent: Wednesday, 22 September 2021 6:29 PM To: [email protected] Subject: Re: [BITX20]

I get the message loud and clear, mic, headphones and keys to be on the front panel. I will probably bring out a usb socket on the side/back. you won't need it much as the built-in sd card will have

Ashhar RF is a problem best avoided Flex and K4 would be to awkward to take tramping, best used at home, with a foot switch. not in a small tent I have a V4 uBitx, If I was to operate it only from

I have a 6400 and I really like it. However, it is not easy for me to move it to see the back of the rig. Therefore, any time I want to plug in a key or change the mic, I have to go to the user's

The mic is a peculiar beast, routing it to the back makes it pick up the RF from then PA. Having said that, I saw flex and k4 provide a separate jack for ptt. It makes it easier to wire in a foot

I agree. Jack, W8TEE

It's bolted down in the truck really good so not much chance of that!