开云体育

Another

Another

Here are more pictures.? The steel bar is what I was going to use to fab a different style mount...like the one in the first photo. And once they get approved...here:Yahoo! Groups | | | | | | | | | |

braze it

Any welding forum has a statement that is used all the time. Cast iron breaks and if welded it will break again. Build it from iron and go to bed knowing it will work tomorrow! DBQ49er [4x6bandsaw]

It sounds like you have a small piece that is broken off and not a major casting failure. If that is true id fabricate new parts out of steel. I certainly would avoid trying to weld the old cast iron.

https://groups.yahoo.com/neo/groups/4x6bandsaw/photos/albums/1957608922/lightbox/1926388659?orderBy=ordinal&sortOrder=asc&photoFilter=ALL

Here is a picture of an older saw. It is the design I am going to try to use to fab a new motor mount. This one only has a bolt on one side....the right. Mine will have one on each side.

Brazing is an alternative.?Leon Robinson ?? K5JLR Political Correctness is a Political Disease. To: "4x6bandsaw@..." <4x6bandsaw@...> Sent: Thursday, March 1, 2018 11:34 AM

Send a pic. I bet it would be easier, and stronger, to fabricate one. You need nickel rod to weld cast iron, and it does not weld like steel. Preheat is important, and stress relieving as it cools is

Preheat to 500F, then weld with the appropriate filler rod/material you are using. Rick Sent: Thursday, March 01, 2018 12:25 PM To: 4x6bandsaw@... Subject: [4x6bandsaw] Re: Broken Motor

I have a welder....I just never welded cast iron before. Not sure the best way to tackle this.

On 3/1/2018 11:07 AM, Terry Coombs snagone@... [4x6bandsaw] wrote: > > On 3/1/2018 8:40 AM, aaarneson@... [4x6bandsaw] wrote: >> >> I have a HF style motor mount that has the cast iron

Ok...I have never welded cast iron before. Also I don't have a mill. But I will still post some pictures.

I have re-weld cast iron before and that's why I would like to see pictures. You have to clean it up on a mill but might be an option. [4x6bandsaw] <4x6bandsaw@...> wrote:

I will try to post up a picture this afternoon.

Thank you. I will give them a call.

On 3/1/2018 8:40 AM, aaarneson@... [4x6bandsaw] wrote: > > I have a HF style motor mount that has the cast iron plates...I wish I had a picture...may I can send one later. > > > It appears there

please send a picture! 4x6bandsaw@...> wrote: