开云体育

I have the Harbor Freight version... It's been many years since I did this, so I hope myu memory is accurate. I pulled things apart to make a new shaft for the bottom drive wheel - and when I did, my

How to?? How do I remove the gears (well worn gears)? Ralph [4x6bandsaw] <4x6bandsaw@...> wrote:

Hi and welcome to the group I'm rather surprised that you have had to replace bearings as they generally last well A far more common problem with these is that the soft brass gear wears our very

Thank you for allowing me to join this group! This is my first post. I own a Clark Metalworker 4x6 and have used it in my hobbies for many years. The bearings in the gearbox have finally worn out and

No base, just the sheet metal legs. I'm in NY, 11747 Zip Code.

Hi, Where are you located? I would be interested in the saw base if not too far from me, im in San Diego. J Estrada

Would anyone want a table and set of legs for a Harbor Freight 4 X 6 bandsaw? Never used, 3-4 years old. Free for the cost of shipping.

If you have a Stick/Arc welder you can try this rod below to weld Cast Iron Joe

I welded what I thought was cast iron with nickel rod many years ago using an ac welder. ?The rod was expensive but ran really well and held. ?Good luck what ever process you use or if you fabricate

I am not a welder, I fit the saying "A lot of grinding and a little paint, makes me the welder that I ain't"... However, having said that I broke the jaw on a five inch vice. I ground out a good "V"

OK I've done repairs to cast iron on my bandsaw before... it may or may not be possible due to the size of the piece and the equipment you have available. To weld it doesn't require special welder

Here's another: http://www.torchweld.com/products/153-video-welding-cast-iron.aspx Ken :-)

Not true. Cast iron can be gas welded using cast iron filler. Cast iron piston rings can be used as filler. High temperature flux is required. https://www.youtube.com/watch?v=zyX7tdG84vk

Thanks everyone. I will try that plate idea. I have the square tubing finished. Just need to tap the holes.

Hi When making a new motor mount you might consider a different way of tensioning the belts too. The std saw pulleys have a different belt length for each speed, which means you have to re-tension the

Oh crap I overlooked that. I just ordered parts for mine from grizzly I hope they are the same as Harbor Frights saw.

I think that the bigger problem is that the pivot lug is snapped off. To: 4x6bandsaw@... Sent: Thursday, March 1, 2018 6:43 PM Subject: [4x6bandsaw] Re: Broken Motor Mount - Need

would it be possible to drill another hole in the motor casting and move the bolt over?

You said you had a welder. Gather up some mild steel plate, and build a new one. The plate on my Grizzly saw is a formed piece of steel. It would be easy enough to clone & fabricate. Sent: Thursday,

Another