开云体育

That looks pretty good to me!? Nicely done.

I messed around and somewhat failed but it's a start. Open to suggestions but the trunnions seemed to work. https://photos.app.goo.gl/QRS9D3Q3ejbxPQXE8

My approach approximates what a real trunnion scheme would do, given the added degree of freedom provided by the screw that attaches the two pieces of my support bracket together -- it permits the

Cool...? Yep, the trunnions are the hard part. I understood the work around but didn't quite understand how it worked

That was the object of the blade guide modifications I did and posted about here a little while back.? Post #16219.

Sorry it was not clear Mark. Hopefully pictures 2 & 3 below will set that right. The adjustment screw/bolt through the back of the guide bracket casting bears on the 5/16" bolt clamping the guide

I'm not sure i understand this modification. Does the small bolt on the side push against the key to stop movement. Most horizontal saws I've seen have terrible blade guides but these are the worst.

Popping the blade off the bottom wheel (esp. when cutting in the vice or pushing hard on the blade in vertical mode) is very likely due to the bottom guide bracket (the casting with the two side guide

I've got an older harbor freight 4x6 bandsaw that is probably 20 years old. It's green if that helps, and if I saw lightly, in ether horizontal or vertical mode, it seems to work. If I push on the

I buy the supercut bi-metal blade from Harbor Freight. ? I wait for a coupon. ?Item 97119. ?I find?the Super Cut bimetal blade lasts a long time and I haven’t ever had one break. i have tried

For my 5x7 JET horizontal metal bandsaw I buy *Q ? 601 Series - Qsaw ? M42 Bimetal* * *0.5 x 10-14 (0.025)* @ 5' 4 1/2 " * ** from sawblade.com. The reduce per-blade shipping costs and gain a small

Hi Paul I've done a bit of study on all the blades I can get in NZ and can say from experience I can detect no difference in the cutting ability of any of them, which is not to say that they were all

Just a guess….but I figger Bosch built ‘em, Lowe's bought ‘em, and if you buy ‘em, they are yours! That said, I buy Lenox bi-metal blades, from https://www.bandsawbladesdirect.com/ Other

whose blades are they ? animal

Well we sell for $10

I've been buying Bosch blades at Lowes , I think their @ 12-14 bucks . They cut good & seem to last . animal

You can get back to me if you wanna buy [email protected]> wrote:

What is everyone buying for saw blades these days and where are you buying them?

You're welcome! Other Bill -- This email has been checked for viruses by Avast antivirus software. www.avast.com

Just needed 2 cuts at 18 but the only picture I had, I have made an occasional cut at 45 never 60