开云体育

Hi, v1.1.9 resolved the inoperative TX RF output issue occurring with my x6100 and initial test results are very good. NQ4Y

Xiegu X6100 Firmware Update v1.1.9 (2024-09-15) *NOTICE* : The v1.1.8-240904002 update was withdrawn on request by Xiegu. If you have updated your X6100 and experience TX failure issues, this update

Go a few questions in private email, to clarify a little; This update is received directly from Xiegu tech department. The previous version 1.1.8 was not fully compatible with some of the hardware

Thanks Georgy, sounded cut off like an older telephone capsule microphone ;) now like it has to be! Xiegu always makes there radios worser than they are due to dilligence. Not only in the software,

The new FW v1.1.9 from Xiegu with fix for the TX issue is available from Xiegu.eu. On our request the color scheme has also been updated for better visibility, now white text on blue

Hi Testes yesterday the 0.2.4 Firmware. Had it Running whole afternoon in ft8 Mode receiving, when Train to Switch back to normal Mode aft er some Hours, the Display was frozen, vfo functioned. To

After success connection to WiFi you will see: * DISCONNECT label for button * connected text on your wifi item. Also, you can try to turn on DHCP (like on picture). Then use name xiegu-X6100 instead

... also if I`m with both (Computer & X6100 ) directly located at the router ... and in the same network I get no access to the X6100 . All entries are correct in WinSCP (or FilZilla too), but the

I created a version with fix: 0.24.1 https://github.com/gdyuldin/x6100_gui/releases/tag/v0.24.1 All dependencies was on their places, but order of building was wrong.

Yes, I used https://github.com/fventuri/BBFW to decompile, than find similar place in 1.1.7 and patch it. Don't forget to decrypt before comparing.

Easy to install Gregory and worked perfectly. Nice low response and I think it improves the built in microphone response but maybe it's my imagination (but I dont think so, the internal mic seems more

Awesome! Sorry for quick reply I’m on mobile but this is awesome! I’m guessing you found the hex address for the passband filter limits? If so I can hex compare your version to the original and

Absolutely correct.

This firmware is independent from the R1CBU. Using R1CBU will not change BASE firmware. Also - this patch might be used with original and R1CBU. It's just for another part of the radio.

This filter (300-3000) applies only during TX. Looks like BASE applies some filters to input IQ signal before demodulation, but I'm not investigate this huge part of firmware yet.

I'm using USB type Ethernet adaptor to connect radio, seems I never connect it to my WiFi - so I have no advice. Only one thing - wifi antenna on the transceiver is very small - it might be helpful to

Looks like I missed something in the base image. Will check and publish a fix.

Hi Georgy Great work. Unfortunatelly got stucked with 'Problem with create file' when trying audio record. Before, it was ONLY with missing *rec/* dir in DATA part. Now rec/ dir got populated with

Hi Georgy, Great work. Unfortunatelly got stucked with ' *Problem with create file'* when trying audio record. Before, it was with missing *rec/* dir in DATA part. Now rec/ dir got populated with

I wonder if my understanding of your post is correct: Filter High/Low change, or DFL FIL1..3 (in OEM) does ONLY affect RX and no changing TX passband?