开云体育

Yes, on the fldigi config/Contest/General page Initalize the serial number process with entering a starting serial number then click Reset. Of course remember to increment the serial number after the

I tried this <TX><CALL> 599 <SERNO> TU GL <MYCALL> <LOG> <RX> But it did not print or send a serial number. Isn't there something that should be entered in the Contest / General,? ?(Contest Exchange

It looks like the OP NOTES field for the address and signature in FLMSG are not cleared when a new message is loaded. This appears to add the old OP NOTES to the new message,

Ken, Use the <INCR> macro command to increment the SN. Be sure to initialize the serial number in the General Contest config by choosing a starting number and then Reset. 73, Cliff, AE5ZA

Can Fldigi be setup to where when I am doing a contest, and sending the Message by macros that the serial number info can be automatically increased each time in the message I send. Or is there a way

The rig IC-7100, has macros for cw. There is no delay when the rig sends characters. ?Microham has macros you can send by keypad. I don't have a keypad but there is a provision to test the macros, no

Thanks Cliff for the reply. I got FLRIG and FLDIGI working after a change in some minor changes. Works great now!! -- WIN4ICOMSUITE MACRO FILE CQ,NU4N NU4N BK 599,UR 5NN KY NU4N,5NN KY BK , , , , , ,

In flrig config/PTT-Generic be sure PTT CAT is set to Both. 73, Cliff, AE5ZA

How are you trying to get it to transmit? 73, Cliff, AE5ZA

Page 68 section 4-3 explains how to adjust the delay. This is in the FULL manual. Ed W3NR

There are no settings in fldigi that will cure your problem. Take a good look in the rig menu and look for any delay settings for CW. That is where I found my problem and some tweaking fixed the

*I just purchased a ICOM 7300. I have FLRIG showing my freq. But I can't seem to get it transmit. Any help would be appreciated.* -- *73'S DAVE NU4N*

I am using fldigi 4.1.22 to command the winkeyer in my Microham Digikeyer 2 (DK2). The cw has a definite pause between characters. ?If i drive the winkeyer from cw memories in Microham software it

Here is my macro for weather at Gerald R Ford airport, Grand Rapids, MI <WX:KGRR>?? and I save it to one of my fldigi buttons which I name WX KGRR Onscreen when I hit it I get (in the transmit box)

*METAR* - *METeorological Aerodrome Report https://en.wikipedia.org/wiki/METAR *

Tnx for al the advice, I reinstall FLDigi with mt MKII? delete everything and install fresh. now it works fine with FLrig. not with the bridge with DXLabs. But it works! Rien, PA7RA

Please share how. Tnx. [email protected]> wrote:

so are you saying that just by sending <METAR:KBOS> I. An get a reply from someplace to what the METAR actually is? ? What frequency?

Ah Ha...found it!