开云体育

Thanks for the reply...I am using COM port to toggle, configured in fldigi Hardware PTT. ~R~

Tobias Thanks for a) recommending the audio file. I have not used it in the past, and forgot about it. b) the config menu. It turns out that I already have ending RSID OFF. For personal reasons, I

is this with a vhf/uhf HT or hf HT?? are you using vox to key? it sounds like the ptt is dropping as expected, increase the vox delay. does any results ( answers) come back to your

Hi Rich, Maybe it's easiest to 'Menu - File - Audio - TX generate' a short wav file with the respective audio produced by FLdigi. Before using the audio file, make sure to repeat the same Menu

I found most of the delay. I automatically turn on RXID and TXID in my macros to select the modem protocol. So fldigi must send the ID at the start of the transmission. Not sure why it then sends

If TXID (and RXID, I suppose, though it shouldn't have an effect) is turned off, and I toggle T/R, I see fldigi TX something at the beginning and the end. I don't have anything in the TX pane to

I am using a digirig 1.9. Windows 10 fldigi 4.2.06 If I select Tune, when I toggle it off, PTT drops within 1 s. If I toggle T/R with no data to send (just for testing), the delay is there after I

Hi George, If you are comfortable editing an FLdigi config file, you can try this sequence (back up the original file before, in case there's an issue): 1. Close FLdigi. 2. Open 'fldigi.prefs' in

I don't have mine handy, but ISTR that all you do is drag the divider... 73 Rich NE1EE The Dusty Key On the banks of the Piscataqua

It would be nice if there was an option to hide the TX portion of the screen to allow more room for RX traffic. I am not doing any transmitting and I am sure other hams and SWL folks just might

I found "Hamrs" software to assist in logging Pota stations, and although there are a few settings I don't like, this email is to ask about the server/client option flrig provides ( used by

Thanks again Robert. I was trying to help a friend. The blind leading the blind, with the ignorant for consultation. ? Bill [email protected]> wrote:

Bill, Looked over the source code related to your question. The widgets in question is a custom UI element and the code contains no assignment (text message) to the tooltip() function. The reason

Don and Robert, You're the best. Thanks. Robert, you answered the question I didn't even ask, but was thinking about! Bill [email protected]> wrote:

Under Fldigi Configuration->Configure->UI->General is a checkbox in the upper left hand side of the dialog box named "Show tool tips". Make sure this is selected. Hover the cursor over the UI in

This depends on the rig and the rig control software being used. In general, the left hand field displays the mode of the rig IF this is handled by rg ctonrl software. In general the right hand

I have a super basic question. What is the section of the UI called that contains the frequency window, the logging area, etc., and specifically, the mode and bandwidth section called? It's the area

I think the issue is the sound card does not have a wide enough bandwidth. j [email protected]> wrote:

Hi all, Just a little quirk I noticed (and which caused me quite some cursing and despair): When the FT-818 is in WFM mode (say, used as an ordinary FM radio receiver for your favourite FM

Tnx Dave! Hope all is well with you guys and Hello to Skip! 73 de Steve