开云体育

Hello Tobias, Thanks very much for the detail on the UI Scheme setting location.? It had moved from where it was previously located. I had already set the waterfall height to 100, which is the

Hello George, Please simply make your favorite setting in the 'Colors-Fonts - Buttons-Menus' section, see attachment. In case you care doing so, you can now even change the Menu font (and size!),

Please see the attached picture.

I just installed the latest FLDigi update (4.2.06) after not updating for a number of years.? Has the plastic-looking option been removed for displaying macro buttons, as described by Ed, W3NR,

Thank you David for your reply. Is this something that could be added in a future version of FLDigi? Regards, George

Hello Rich, Sounds like a great system to have all stations on the same page,so to speak. For comparison, we had our weekly DL0BS QTC here in Bavaria last night, as every Monday evening from 1900

GM, Tobias, Locally, when we start a digi net, NC sends a Tune. 1. This allows RX stations to adjust their radio+hardware sound card+CODEC+fldigi so that they have a clean sig in the SIG panel. I

The ITA2 character set is not a part of fldigi, but easily added (or substituted). You would have to modify the source code file rtty.cxx and recompile fldigi. David [email protected]> wrote:

Good morn' back to you, Rich. All agreed as you state it below. I guess the trailing center tone is intended for 'listeners' to help them center their receiver or fldigi offset. I don't see a

Good morn (here On the banks of the Piscataqua, anyway ;-) Thanks for the reply. Tobias earlier reported in a different thread on a related subject: "Your wav file signal looks exactly as expected: a

Hello George, I wasn't aware this 'reset' might happen once the values were manually set. To prevent any direct FLdigi induced modifications, you can, of course, edit the fldigi.prefs file and

What “mode” are you using when you see this? I think all Thor modes do send a string of characters ?to “clear the buffer” I hear it go fom low to high pitch tones like a trombone. Go to

Hello Tobias, Well the issue has returned with the wide gray area where the TX text was.? What is strange is that when I close the program the "int_tile_y_ratio:" is reset to 835, it's original

Hi George, Thanks a lot for sharing your experience. Since we kind of tweaked the 'standard' user interface behavior, it may well be that the full height is not updated until you restart FLdigi. So

I just tried it again after closing the program and things now work as they should.? I will keep an eye on it. Regards, George

Greetings, I like to decode the Europe feed of news items as described at RTTY.com. Please see the attached picture. The gentleman that is one of the go-to people on this replied to by question as

Sorry, I forgot to post the image.? Look at the one with blue text.

Hello Tobias and Rich, Thank you both for your replies.? Rich, I did lower the TX area as much as possible, but it still had a few lines of height.? Tobias, I had to user 1100 as the magic number

Best wishes to you in Bavaria! 73 Rich NE1EE The Dusty Key On the banks of the Piscataqua

Hi Rich, Thanks for your detailed reply and the wav file. Your wav file signal looks exactly as expected: a leading short (1 second) center frequency tune tone, followed by the (non-)message