开云体育

ok, after loading stm software, and tinysa-app software, i then went into the device manager, left screen there, connected usb cable, turned on tinysa, got beep on computer but no sign of driver, then

Did you look at the examples in the wiki? -- ------------------------------------------ For more info on the tinySA go to https://tinysa.org/wiki/

Im ultra interested in this, Im trying to build an amateur radio repair station. AMATEURE... I think a TinySA, NanoVNA, a Tracking Gen all in one box would be a VERY VERY good solution. I already have

As the cloners are probably reading these messages I prefer not to explain how I know a product is a clone. -- ------------------------------------------ For more info on the tinySA go to

Mario, As all levels are way too high you its hard to believe its a attenuator problem. Could you start with CONFIG/LEVEL CAL/RESET CALIBRATION The levels indicators at the left of the grid should

Hello ae1th, can you send me your driver even if you suspect it's trojanned, i want it? I will mod it and upload it here. Sent with [ProtonMail](https://protonmail.com) Secure Email.

Hi Jim, sorry I don’t understand. could you elaborate and maybe a photograph please? it would be greatly appreciated. Regards Chris -G0SMO

Hello Eric, How can you tell from the picture that it a clone ? Vidas

Well, I seem to have done something stupid and believe I have a failed attenuator. I was debugging a new SSB exciter capable of only about +10dbm maximum at best case - which the spec seems to show

I had to update a driver on Windows 10 in order for the TinySA to be seen. I just went to updates in Settings and let windows update the driver for me. Hal

had same problem here, used tinysa-app , for 4 hrs for 2 days, looking thru sub folders i douna a folder with drivers for win 7,7,10. using win 10, tinysa-app finally saw the tinysa, just by trial and

Mark, If you installed DfuSe tools correctly, then when running DfuSeDemo the tinySA will appear as "STM Device in DFU mode" not as "tinySA" under "Available DFU Devices". - Herb

Hello to all, I am trying to load the updated firmware to the tinySA, but when I go to put th3 file in the DFU File Manager, set the tinySA to DFU mode,I cannot see the tinySA in the Available DFU

mine broke 1hr after getting my vna but rather than changing the switch i think i will go with a much simpler solution (for me) and just replace with 3 regular miniature push button switches and in my

Thank you Erik!

Sorry, but this is an illegal clone. No doubt. A very nice visual copy, but not at the right performance. -- ------------------------------------------ For more info on the tinySA go to

Seems authentic.

Robert, I'm not sure this is a genuine tinySA Can you post photos of the sticker on the back and the PCB? ------------------------------------------ For more info on the tinySA go to

Look at eBay item 121096249091. SLLB310400 ALPS. I bought two when I needed one. 73 -Jim NU0C "Robert Entwistle" <rentwist@...> wrote:

I've just updated the firmware with 1.1-77 and my unit with the S/N: SA-20080475 works fine. The self test and the linearity test are all OK. Happy days!