开云体育

A quick update, I started a claim with AliExpress, sent them a copy of Erik's message confirming it was a clone. Seller requested the clone returning for a refund...but after a few days AliExpress

Oh I see. many thanks for that Jim. I just used a phone screen protector that I had laying around, it did the job well.

It depends on how selftest 7 fails but for the clone I expect it won't meet the specs regarding power level accuracy and it will have more spurs. -- ------------------------------------------ For

It appears I may have the same clone except mine only fails self test 7 with screen very similar to the one posted above.? After many repeated test runs test 7 is the only one that fails.?

Looks like I've bought a clone too unfortunately. I didn't know clones were even a thing until it was already here. The wiki and this discussion group thing need a much better design with more obvious

Anyone have a source for a metal case for the NanoVNA-H4 model??

Same concept as putting a screen protector over an LCD except you are using clear packing tape. The result resembles a laminated document and protects the label from daily

There is a mod section that shows a mod using 3 push button switches. Shows where to connect them I am getting a metal case for my TinySA. I already. Got one and installed my NamoVNA H in it. The only

ok, after loading stm software, and tinysa-app software, i then went into the device manager, left screen there, connected usb cable, turned on tinysa, got beep on computer but no sign of driver, then

Did you look at the examples in the wiki? -- ------------------------------------------ For more info on the tinySA go to https://tinysa.org/wiki/

Im ultra interested in this, Im trying to build an amateur radio repair station. AMATEURE... I think a TinySA, NanoVNA, a Tracking Gen all in one box would be a VERY VERY good solution. I already have

As the cloners are probably reading these messages I prefer not to explain how I know a product is a clone. -- ------------------------------------------ For more info on the tinySA go to

Mario, As all levels are way too high you its hard to believe its a attenuator problem. Could you start with CONFIG/LEVEL CAL/RESET CALIBRATION The levels indicators at the left of the grid should

Hello ae1th, can you send me your driver even if you suspect it's trojanned, i want it? I will mod it and upload it here. Sent with [ProtonMail](https://protonmail.com) Secure Email.

Hi Jim, sorry I don’t understand. could you elaborate and maybe a photograph please? it would be greatly appreciated. Regards Chris -G0SMO

Hello Eric, How can you tell from the picture that it a clone ? Vidas

Well, I seem to have done something stupid and believe I have a failed attenuator. I was debugging a new SSB exciter capable of only about +10dbm maximum at best case - which the spec seems to show

I had to update a driver on Windows 10 in order for the TinySA to be seen. I just went to updates in Settings and let windows update the driver for me. Hal

had same problem here, used tinysa-app , for 4 hrs for 2 days, looking thru sub folders i douna a folder with drivers for win 7,7,10. using win 10, tinysa-app finally saw the tinysa, just by trial and

Mark, If you installed DfuSe tools correctly, then when running DfuSeDemo the tinySA will appear as "STM Device in DFU mode" not as "tinySA" under "Available DFU Devices". - Herb