开云体育

I found that tones below 100.0 could be problematic with some truck installations. The gravely and loud voices into the mic could false trip with some users. 73 Don ve3ids yahoo.com@groups.io>

I would avoid 118.2, 179.9 and 241.8.They are close to 60Hz harmonics.I had a repeater on 118.2 and it would false everytime the A/C or Heat kicked on.Changed to 885 and the problem was

Have you isolated both TX and looked at the spectrum coming down the feedline Ken. If that mp3 is generated by the HT keying the RX > TX, what can you see via the RX or a T into the LDF4-50 VK4JKL

One of the local UHF repeaters had a jumper center pin desense problem, but that was with the opposite condition where below a certain temperature the center pin pulled apart more. I do not remember

Oops, that should have gone directly. sorry BTW, I could never use the Austin. VHF side runs 125 watts, UHF 90 watts! Ken Couldn't access the antenna today (only way is with a bucket truck). I

BTW, I could never use the Austin. VHF side runs 125 watts, UHF 90 watts! Ken Couldn't access the antenna today (only way is with a bucket truck). I figured we'd check that joint when we access

Couldn't access the antenna today (only way is with a bucket truck). I figured we'd check that joint when we access it Ken

Next guess would be the Center pin of the connector is sunken in just enough to be a problem. arcomcontrollers.com@groups.io> wrote:

Screen shots of attempting to put oem file back into the machine showing the password of LOST as instructed per rss

Not from my opinion ? I'd be checking the antenna to tube interface.... just sayin' Matt AL0R

Avoid 179.9 Hz

No I meant of the programming software where it says you need a password yahoo.com@groups.io> wrote: > >

At 1/8/2025 08:41 AM, you wrote: When you think about it... Thoughts by Larry W8LM.... Given the fact - any one knows to find the top of a high rise, or a water tower hospital or some altitude,

Take a screen shot of what you are talking about and a picture of the LEDs on the front of the station please. yahoo.com@groups.io> wrote:

After heating with a heat gun and cooling with freeze spray, everything in the rack (and also bypassing the diplexer), nothing made a difference in the appearance (and disappearance) of the crackles

At 1/8/2025 04:51 AM, you wrote: You'll find that most of the country is high in, low out on 440... If you go 442.xx out, 447.xx in, the 450 commercial shouldn't bother you..unless you are at a high

I have a question. What scm can I not use. Found an epic V with a wireline board but I know some are for trunking only. im at the point where im pretty sure I will need a new control module especially

My goto - 1Z (100.0) Ken ------------------------------------------------------------------------------ President and CTO - Arcom Controllers Makers of repeater controll

Very interested. I’m able to communicate with the machine but this password thing is beating me I. The head with a large lead pipe. email me directly and I will happily take whatever you may have.