开云体育

Avoid 179.9 Hz

No I meant of the programming software where it says you need a password [email protected]> wrote: > >

At 1/8/2025 08:41 AM, you wrote: When you think about it... Thoughts by Larry W8LM.... Given the fact - any one knows to find the top of a high rise, or a water tower hospital or some altitude,

Take a screen shot of what you are talking about and a picture of the LEDs on the front of the station please. [email protected]> wrote:

After heating with a heat gun and cooling with freeze spray, everything in the rack (and also bypassing the diplexer), nothing made a difference in the appearance (and disappearance) of the crackles

At 1/8/2025 04:51 AM, you wrote: You'll find that most of the country is high in, low out on 440... If you go 442.xx out, 447.xx in, the 450 commercial shouldn't bother you..unless you are at a high

I have a question. What scm can I not use. Found an epic V with a wireline board but I know some are for trunking only. im at the point where im pretty sure I will need a new control module especially

My goto - 1Z (100.0) Ken ------------------------------------------------------------------------------ President and CTO - Arcom Controllers Makers of repeater controll

Very interested. I’m able to communicate with the machine but this password thing is beating me I. The head with a large lead pipe. email me directly and I will happily take whatever you may have.

I would avoid 118.8, as people with AC hum could trigger it. Other than that, try to avoid any interfering tones of co-channel repeaters (that's the whole

Are they all on the same frequency or different frequencies?

I recently acquired a few SCMs - one of which appears to have had the front push-buttons broken off, perhaps in shipping. I was going to attempt to repair it, but it may be a good parts donor for your

Good to know!

That is all Ken

Normally, your coordinator will assign a tone frequency, usually the same tone for every other repeater in the area.

You would of seen text on the terminal program and as you type it would echo back what you are typing if the SCM card was booting and functional. Whatever terminal program you use make sure you set

Are there any best practices or pitfalls to avoid when selecting a CTCSS tone for repeater input? Thanks in advance for your responses. I can think of: 1. Try to pick the same tone frequency

Hello, Are there any best practices or pitfalls to avoid when selecting a CTCSS tone for repeater input? Thanks in advance for your responses. All the best, Mickey

Have the following crystals for sale for five dollars plus shipping