开云体育

IIRC, there are a few boxes you have to correctly set the audio. I ran into the same issue first time I did an R1225. Andy (TARRA) via groups.io <tarra@...> wrote:

I didnt explain it very well. In order of appearance from the antenna: 1. 144.610 rx? ? ? ? ? ? ? ? ? ? ?c2037 2. highband vhf rx? ? ? ? ? ? c2037 3. 145.210 tx? ? ? ? ? ? ? ?

He did say "the "flat audio" check box enabled in the RSS software.". Mick - W7CAT

You have to change it in CPS. Show the screenshots from CPS, then we can help. Thanks Andy WJ9J [email protected]> wrote:

Good Day All, Just reaching out to see if anyone has had any issues with Motorola RKR1225 repeaters not producing flat audio on pin 11 of the accessory port with the "flat audio" check box enabled in

Ya I had seen that one and it was tempting, 6-7 hour drive for me. Kory Links: ------ [1] /g/repeater-builder/message/215400 [2] /mt/103940517/6175112 [3]

All, I am looking for 1-2 Micor Mobiles and/or 1-2 GE Mastr II mobiles potentioally a station if the price is right and its close etc. I am looking for 100-110w radios, on UHF 450-470mhz.? Please

If your near Kentucky, there is one listed on Fleabay.

Repeaterbuilder has the diagrams for other cables. Can't you use that schematic? or do you need the pinout of the mike connector? Joe. K1ike

That's it!! Tnx John!! Chris WB5ITT [email protected]> wrote:

Chris, I think that Rob Riggs had something here https://nbviewer.org/github/mobilinkd/KenwoodTK-x90/blob/master/Kenwood_TK-790.ipynb <setxtelecom@...> wrote:

Due to my former company keeping my Kenwood programming cables, I'm kind of stuck right now. I've got two tk790s I need to reprogram the frequencies and I know that front panel programming won't allow

It all depends on where you're shopping. I find good deals on Facebook and the internet for antennas and I bought a duplexer out of the city of Auburn California, a TX RX 2 m 6 inch cavity version for

I get a discount at Tessco, but with shipping the DB224-E was going to be $2K, tariffs hit aluminum antennas hard, duplexers jumped up too. I ended up ordering a Sinclair Aurora, that was $1500

I assume the c2037 was ahead (closer to the antenna) of the ham rx of 144.61 on the duplexer on the bottom???? The notch cavity of that c2037 if set to the normal notch depth will add to the loss of

I just bought two with the voice board for $100.00 Sent from the all new AOL app for iOS

Well then I discovered most of my questions were answered a couple days ago.? And the chart confirms my measured isolation of ~35 dB

I started a new thread for this as the most relevant was from 2010 I have a site with a couple of highband vhf repeaters as well as a ham machine on 145.210 -600. One of the highband repeaters is on a

hy guys, how much can i ask for an Zetron Maz 48 these days on the used market! i need advise , thanks gervais ve2ckn

I am familiar with that controller. I have two of those. Was trying to find something used that would be quite as much money but decided to pull the trigger on a new one from Ken. So guess I'm not