开云体育

There is a hack to one of the files to make the .09 software wide band without the entitlement key. Personally I just use .08 ... I've taken radios that were narrowband and use the wide band software

Wildcard programmed in the MTR? I take it you're using a transistor inverter to talk to the USB which normally requires a low going signal? Chris WB5ITT <dwisdom-lists@...>

I retuned my DB4060 by first tuning the bandpass on all four cavities to the correct frequency and then going back and tuning the notches for minimum signal pass through on the notch frequency.. I hit

A little too much mutual coupling there ? Chris WB5ITT [email protected]> wrote:

There is a significant difference between the 750/850 and the 751/851 in the speced output power ranges. The 750 range is 25 - 50W, the 850 range is 25 - 40W, and the the 751/851 range is 1 - 25W. As

If you might have some of the KXN-1039 channel elements on GMRS repeater transmit (462 MHz) or repeater receiver (467 MHz) frequencies, please drop me a line. spencer12345@... Thanks!

I was recently sent this photo after donating a Kreco C-36 colinnear vertical for a local 6 meter repeater project. Got a message am that they were experiencing high swr. The antenna is factory cut

Karl, no technical measurements have been made. tnx Mike / K5JR Alpharetta GA

Might not be what your looking for. I used 2 mag mount mobile antenna's on a PVC pipe with a simulated platform to show the different levels of separation as if was on a tower to demonstrate the

Hi Chad, Just wanted to double check if these are the proper model of SLR5700.??? Is the average price between 2K to 3K for a good unit? Ebay link:

I'll keep that in mind, Mike since this is the first time I heard of this. Perhaps in my searching I passed it by because of the lenght.? Did you happend to measure the return loss? -- - Regards,

There’s a software pack for the D revision of the 2600 series on Repeater Builder if you know where to look. I’ve tried it on my 2600C and it didn’t work. I know the 2670s are different and the

Hi Gerald, There is tuning advice on repeater-builder.com for this model. ? And many others here to help One thing I do want to say is that if the club is planning on taking this and using it on a

I have zero experience tuning duplexers but I have been following the repeater builder list for several years, trying to learn and because it is so interesting. Recently, our club

p.s. I do have a copy of the manual. -- Thanks, Randy. randy.ab9go@...

Hello everyone is the subject says I have a new to me Motorola r-2001b.? It came with the cover and all the accessories except for the CRT sun shield.? CRT is in good shape. I was looking at the

All, I have a MTR2000 here that I have interfaced to a USB-RIM module, I have it working in COS mode but want to run a ctcss code on it. I was curious does anyone know if anything special needs to

There is a good comparison in the TKR section of RB. Basically the TKR851 is the same vintage as the TKR850 version 2 which gives a few improved features that the TKR850 version (1) does not have,

The 751/851 were originally the "European" versions but JVCKenwood brought them into the US market a few years before the line was discontinued. The ONLY difference between the 750/850 and the

I understand that the 851 is a lower wattage unit. Other then that not sure what else differs. Les Keegan?N4LPK?